Specifications For Certain Pressures And Some Engine Speeds Are Corrected For Heavy Lift Control Caterpillar

Specifications For Certain Pressures And Some Engine Speeds Are Corrected For Heavy Lift Control

Usage:

EXCAVATORSM312 (6TL680-UP),
M315 (7ML1294-UP),
M318 (8AL1853-UP, 6ES237-UP, 8SS461-UP),
M320 (6WL327-UP, 9PS265-UP) EXCAVATORS

Problem:

In conjunction with the listed PIN ranges that are listed above, all machine specifications that are listed in the chart are compatible with the specifications required for the installation of Heavy Lift Control. The following information should be added to existing Service Manual modules until the literature is revised.

Solution:

Use the attached chart in order to update the specifications that are listed. The reference Testing and Adjusting modules that are being updated are:

M312 RENR1180 Test & Adjust Module

M315 RENR1181 Test & Adjust Module

M318 RENR1182 Test & Adjust Module

M320 RENR1183 Test & Adjust Module

COPYRIGHT 1999 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Generator Lead Connections Can Rub Against The Terminal Box Or Each Other Generator Lead Connections Can Rub Against The Terminal Box Or Each Other

SCHEDULED OIL SAMPLING (SOS) RESULTS ON BACKHOE LOADERS SCHEDULED OIL SAMPLING (SOS) RESULTS ON BACKHOE LOADERS

Check For Correct Operation Of Oil Level Switch Check For Correct Operation Of Oil Level Switch

Incorrect Pressure Specification For PiIot System Pressure Test Incorrect Pressure Specification For PiIot System Pressure Test

Tire Performance Problems On Off Highway Trucks Can Be Prevented Tire Performance Problems On Off Highway Trucks Can Be Prevented

Proper Orientation of the Rod Yoke Prevents Interference with the Stick During Extension on Some Excavators Proper Orientation of the Rod Yoke Prevents Interference with the Stick During Extension on Some Excavators

The Fan Guard Mounts May Fail Prematurely on 5110B Excavtors The Fan Guard Mounts May Fail Prematurely on 5110B Excavtors

FINAL DRIVE SPINDLE BEARINGS MAY FAIL FINAL DRIVE SPINDLE BEARINGS MAY FAIL

DISASSEMBLY OF THE STICK CYLINDERS AND OF THE BUCKET CYLINDERS MAY BE DIFFICULT DISASSEMBLY OF THE STICK CYLINDERS AND OF THE BUCKET CYLINDERS MAY BE DIFFICULT

Some Pumps May Have the Incorrect Actuator Some Pumps May Have the Incorrect Actuator

THE WELD BETWEEN THE TOP PLATE AND THE SIDE PLATE BELOW THE STICK BRACKETS MAY CRACK THE WELD BETWEEN THE TOP PLATE AND THE SIDE PLATE BELOW THE STICK BRACKETS MAY CRACK

Some 2P-4472, 7G-0825, and 8P-1656 Clutch Plates May Have Been Shipped Into the Parts System Before Finish Grinding Some 2P-4472, 7G-0825, and 8P-1656 Clutch Plates May Have Been Shipped Into the Parts System Before Finish Grinding

Can Not Perform Calibration Of The Governor Actuator With The "PDT" Or With A Laptop And M300 Technician Or Engine Constantly Runs At Low Idle Can Not Perform Calibration Of The Governor Actuator With The "PDT" Or With A Laptop And M300 Technician Or Engine Constantly Runs At Low Idle

Gear Pump For The Brake, Pilot And Steering System May Have Failures To Front Bearing Or Front Shaft Gear Pump For The Brake, Pilot And Steering System May Have Failures To Front Bearing Or Front Shaft

Inspect Track Seal Load Rings Inspect Track Seal Load Rings

Oil Pan Cracking Oil Pan Cracking

Unlatched Condition Of Operator Console (Armrest) May Prevent Or Interrupt Machine Operations Unlatched Condition Of Operator Console (Armrest) May Prevent Or Interrupt Machine Operations

Backup Switch For The Auxiliary Controller May Be Wired Incorrectly Backup Switch For The Auxiliary Controller May Be Wired Incorrectly

The Low Idle RPM May Drop Below Specifications The Low Idle RPM May Drop Below Specifications

Oil In Turbochargers Oil In Turbochargers

Governor Instability Governor Instability

Test Procedure For Electrical Components Of Air Conditioning System Test Procedure For Electrical Components Of Air Conditioning System

Remanufactured Water Pump For 3500 Engine Remanufactured Water Pump For 3500 Engine

XT6 Hose On 375 Excavators Replaces The XT5 Hose To Increase Reliability And Durability XT6 Hose On 375 Excavators Replaces The XT5 Hose To Increase Reliability And Durability