XT6 Hose On 375 Excavators Replaces The XT5 Hose To Increase Reliability And Durability
Usage:
EXCAVATORS375 (8XG1-329, 8WJ1-96),
375 L (6RL1-83, 1JM1-410),
5080 (8SL1-110) EXCAVATORS
375 L (6RL1-83, 1JM1-410),
5080 (8SL1-110) EXCAVATORS
Problem:
The XT5 hose may fail prematurely.
Solution:
The XT6 hose is more durable and is used to replace the XT5. All machines built after the machines listed above have the XT6 hoses installed. Refer to the following table and Illustrations 1,2 and 3 for the locations of the hoses and the new part numbers.
7Y8007 Pump (A) Lines Gp.
Illustration 1.
7Y8005 Front Lines Gp..
Illustration 2.
7Y7995 Swing Motor (A) Lines Gp..
Illustration 3.
COPYRIGHT 1999 CATERPILLAR ALL RIGHTS RESERVED
Caterpillar Information System:
Remanufactured Water Pump For 3500 Engine Remanufactured Water Pump For 3500 Engine
Test Procedure For Electrical Components Of Air Conditioning System Test Procedure For Electrical Components Of Air Conditioning System
Governor Instability Governor Instability
Oil In Turbochargers Oil In Turbochargers
The Low Idle RPM May Drop Below Specifications The Low Idle RPM May Drop Below Specifications
Backup Switch For The Auxiliary Controller May Be Wired Incorrectly Backup Switch For The Auxiliary Controller May Be Wired Incorrectly
Unlatched Condition Of Operator Console (Armrest) May Prevent Or Interrupt Machine Operations Unlatched Condition Of Operator Console (Armrest) May Prevent Or Interrupt Machine Operations
Oil Pan Cracking Oil Pan Cracking
Inspect Track Seal Load Rings Inspect Track Seal Load Rings
Gear Pump For The Brake, Pilot And Steering System May Have Failures To Front Bearing Or Front Shaft Gear Pump For The Brake, Pilot And Steering System May Have Failures To Front Bearing Or Front Shaft
Can Not Perform Calibration Of The Governor Actuator With The "PDT" Or With A Laptop And M300 Technician Or Engine Constantly Runs At Low Idle Can Not Perform Calibration Of The Governor Actuator With The "PDT" Or With A Laptop And M300 Technician Or Engine Constantly Runs At Low Idle
Specifications For Certain Pressures And Some Engine Speeds Are Corrected For Heavy Lift Control Specifications For Certain Pressures And Some Engine Speeds Are Corrected For Heavy Lift Control
Quick Coupler Pins Quick Coupler Pins
Material Handler Stick Hydraulic Cylinder Rod Flexing Material Handler Stick Hydraulic Cylinder Rod Flexing
ECM Code And ET Code Cross-Reference ECM Code And ET Code Cross-Reference
Proper Use Of The Wheel Excavator While Traveling Down A Grade Proper Use Of The Wheel Excavator While Traveling Down A Grade
Turbocharger Drain Tube Gasket May Leak Turbocharger Drain Tube Gasket May Leak
Efficiency Check For The Travel Make-Up Flow During Travel Operation Efficiency Check For The Travel Make-Up Flow During Travel Operation
Swing Drive Seals May Be Installed Incorrectly On Certain Large Mining Excavators Swing Drive Seals May Be Installed Incorrectly On Certain Large Mining Excavators
Valve Spring Failures On 3100 Engines Produced By Shin Caterpillar Mitsubishi (SCM) At Sagami Valve Spring Failures On 3100 Engines Produced By Shin Caterpillar Mitsubishi (SCM) At Sagami
Increased Case Drain Pressure May Cause Swing Motor Failure (Reoccurence) Increased Case Drain Pressure May Cause Swing Motor Failure (Reoccurence)
Lower Windshield Glass For Cab Is Identified Incorrectly Lower Windshield Glass For Cab Is Identified Incorrectly
Engine Fueling Overheating Engine Fueling Overheating
Switch Contacts Become Tarnished Switch Contacts Become Tarnished