Fuel System Water Separator - Drain
Show/hide table
 |
|
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. |
Show/hide table
| |
| Illustration 1 | g00467033 |
|
(1) Vent valve
(2) Base (3) Can (4) Element (5) Drain plug | |
Water in the fuel can cause fuel system components to fail. Drain the water separator daily. Drain the water separator more frequently when a large concentration of water is present in the fuel system.
- Close the fuel supply valve.
Show/hide table
NOTICE Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.
- Remove drain plug (5). Depress vent valve (1) in order to start the flow. Allow the water to drain into a suitable container. Allow the water to flow until fuel flows from the drain.
- Install the drain plug. Dispose of the liquid properly.
- Open the fuel supply valve.
Show/hide table
| NOTICE |
|---|
|
The water separator is under suction during normal engine operation. Ensure that the drain valve is tightened securely to help prevent air from entering the fuel system. |
Caterpillar Information System:
3208 Marine Engine Fuel Ratio Control - Inspect/Adjust
P16, P20, P25, P28, P40 and P60 Pulverizer Ring Gear - Lubricate
3208 Marine Engine Engine Oil Level - Check
3208 Marine Engine Fuel System Secondary Filter - Replace
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Description
P16, P20, P25, P28, P40 and P60 Pulverizer Plate Locations and Film Locations
3208 Marine Engine Governor Housing - Drain
P16, P20, P25, P28, P40 and P60 Pulverizer Bushing (Crushing Arm) - Lubricate
3306C Truck Engine Engine Oil Filter Base - Remove
3126 Truck Engine (Military) Commercial Heavy-Duty Coolant/Antifreeze and SCA
3600 Distillate Fuel Engines Refill Capacities
3126E and 3126B Commercial and Truck Engines Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Installation Of The Hydraulic Actuator System (Hydrax System) on G3606 and G3608 Engines {1050, 1250, 1908, 1915} Installation Of The Hydraulic Actuator System (Hydrax System) on G3606 and G3608 Engines {1050, 1250, 1908, 1915}
P16, P20, P25, P28, P40 and P60 Pulverizer Operating Technique Information
3406E, C-10, C-12, C-15, C-16 Truck Engines Starting the Engine
3208 Marine Engine Fuel System - Prime
3126E and 3126B Commercial and Truck Engines General Hazard Information
P16, P20, P25, P28, P40 and P60 Pulverizer Principles of Breaking
P16, P20, P25, P28, P40 and P60 Pulverizer Walk-Around Inspection
3126E and 3126B Commercial and Truck Engines Mounting and Dismounting
3126E and 3126B Commercial and Truck Engines Engine Starting
Installation Of The 129-6628 Speed/Timing Sensor On 3406E Engines{1907} Installation Of The 129-6628 Speed/Timing Sensor On 3406E Engines{1907}
P16, P20, P25, P28, P40 and P60 Pulverizer Specifications
Instructions for the Service Replacement of the Turbochargers{1052} Instructions for the Service Replacement of the Turbochargers{1052}