785G Off-Highway Truck Systems Caterpillar


Front Wheel

Usage:

785G RTL


Illustration 1g06214359

Table 1
Item  Qty  Part  Specification Description 
423-2091 Duo-Cone Seal Gp  Rubber toric seals and all surfaces in contact with the rubber toric seals must be clean and dry at assembly. Prior to installation, apply a thin layer of oil to contacting surfaces of the metal seals. 
314-4119 Duo-Cone Seal Gp 
9X-7442 O-Ring Seal  Lubricate shaft lightly with lubricant being sealed. 
33  2J-3505 Full Nut  Tighten to 880 ± 80 N·m (649 ± 59 lb ft)
5T-6065 Shim Pack  5.55 ± 0.08 mm (0.219 ± 0.003 inch) Refer to the Steering System Testing and Adjusting, "Front Wheel Bearing - Adjust" in order to determine the number of shims to use. 
Mounting surface to be free of paint and grease prior to assembly. 

Caterpillar Information System:

950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Hydraulic Control Operation
PL83 and PL87 Pipelayers Refrigerant Dryer - Replace - If Equipped
2014/09/26 A New Special Instruction Is Now Available for Bypassing EGR Relay in EMCP2 Controls on Certain Generator Sets {1908, 4490, 4493}
PL83 and PL87 Pipelayers Alternate Exit
Cat® Reman Injectors with Invalid Injector Trim Files {1290} Cat® Reman Injectors with Invalid Injector Trim Files {1290}
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Exhaust) - Remove and Install - Selective Catalytic Reduction (SCR) Temperature Sensor
2015/02/19 New Front and Rear Crankshaft Seals Are Used on Certain 3500 Machine Engines {1160, 1161, 7555}
Procedure to Install the 460-7644 Fuel Lines Gp on Certain 24M Motor Grader Engines{1274} Procedure to Install the 460-7644 Fuel Lines Gp on Certain 24M Motor Grader Engines{1274}
785G Off-Highway Truck Systems Steering Gear
C4.4 Engines for Caterpillar Built Machines Ammonia Sensor - Remove and Install - Ammonia Sensor if Equipped
C3.4B Engines NOx Sensor - Test
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Catalyst Inlet) - Remove and Install
785G Off-Highway Truck Systems Liquid Level Sensor (Hydraulic Tank)
785G Off-Highway Truck Systems Pump Drive Group
785G Off-Highway Truck Systems Steering Cylinder
Magnetic Switch Group Fails on Certain 773E, 770G, and 772G Off-Highway Trucks{1408, 7499} Magnetic Switch Group Fails on Certain 773E, 770G, and 772G Off-Highway Trucks{1408, 7499}
785G Off-Highway Truck Systems Steering Linkage and Cylinder Mounting
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Quick Coupler Pressure - Test and Adjust
785G Off-Highway Truck Systems Relief Valve (Steering)
SE60 V Asphalt Screed Machine System Screed Plate
C3.4B Engines Power Take-Off - Test
AP655F and AP655F L Asphalt Paver Machine Systems Deflector
C3.4B Engines Relay - Test - ECM Main Relay
785G Off-Highway Truck Systems Oil Filter (Brake Cooling)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.