SE60 Asphalt Screed Caterpillar

Removal Procedure

Start By:

1. Remove the gerotor motor (screed height). Refer to Disassembly and Assembly, "Gerotor Motor (Screed Height) - Remove and Install".

2. Remove the solenoid valve (height, end gate). Refer to Disassembly and Assembly, "Solenoid Valve (Height, End Gate) - Remove and Install".

3. Remove the extender tubes. Refer to Disassembly and Assembly, "Sliding Guide (Extender Carriage) - Remove and Install".

Show/hide table

Illustration 1	g03683977

Show/hide table

Illustration 2	g03683978

1. Disconnect temperature sensor harness assembly (3).

2. Remove all the cable straps retaining harness assembly (2) and harness assembly (3) to frame assembly (1).
   Show/hide table

   Illustration 3	g03683976

3. Remove two screws (4), the two washers, and strap (5).
   Show/hide table

   Illustration 4	g03683979

4. Disconnect harness assembly (8) from connector (6).

5. Remove the screws, the washers, and two connectors (6).

6. Remove the screws, the washers, and connector (9).

7. Remove harness assembly (2).
   Show/hide table

   Illustration 5	g03683980

8. Remove harness assembly (2), the cable assembly, and strap (5) from frame assembly (1).
   Show/hide table

   Illustration 6	g03683981

9. Disconnect four grease lines (10) from the valve blocks.
   Show/hide table

   Illustration 7	g03683982

10. Remove nut (13), the washer, and the pointer.

11. Remove two nuts (11), the two washers, and plate assembly (12).

12. Remove nut (15), the washer, and plate assembly (14).
    Show/hide table

    Illustration 8	g03683984

    Show/hide table

    Illustration 9	g03683985

13. Attach a suitable lifting device to frame assembly (1). The weight of frame assembly (1) is approximately 54 kg (120 lb).

14. Remove four bolts (16) and the four spacers.

15. Tilt bearing block assembly (17) away from frame assembly (1).

16. Remove frame assembly (1).
    Show/hide table

    Illustration 10	g03684703

17. Remove four bearing sleeves (18) from frame assembly (1).

Installation Procedure

1. Install frame assembly (1) in the reverse order of removal.

   1. Apply Tooling (A) to the spacers.

End By:

1. Install the extender tubes. Refer to Disassembly and Assembly, "Sliding Guide (Extender Carriage) - Remove and Install".

2. Install the solenoid valve (height, end gate). Refer to Disassembly and Assembly, "Solenoid Valve (Height, End Gate) - Remove and Install".

3. Install the gerotor motor (screed height). Refer to Disassembly and Assembly, "Gerotor Motor (Screed Height) - Remove and Install".