14L Motor Grader Caterpillar

Removal Procedure

Start By:

1. Remove engine enclosure.

1. Drain coolant from coolant system into suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC)- Change".
   Show/hide table

   Illustration 1	g03498858

2. Disconnect tube assembly (1) and clip (2).
   Show/hide table

   Illustration 2	g03498862

3. Disconnect hose assemblies (3) and (4).
   Show/hide table

   Illustration 3	g03498864

4. Disconnect harness assembly (5) and remove cable strap (6).
   Show/hide table

   Illustration 4	g03498865

5. Disconnect harness assembly (7) and remove bolt (8).
   Show/hide table

   Illustration 5	g03499116

6. Disconnect harness assembly (11). Remove bolts (9) and (10). Reposition sensor assembly (12).
   Show/hide table

   Illustration 6	g03499222

7. Disconnect harness assembly (13) and hose (14).
   Show/hide table

   Illustration 7	g03499277

8. Disconnect tube (15).
   Show/hide table

   Illustration 8	g03499278

9. Loosen clamp (16) and disconnect bellows (17).
   Show/hide table

   Illustration 9	g03499337

10. Remove cover (18).
    Show/hide table

    Illustration 10	g03499402

11. Disconnect hose assembly (19).
    Show/hide table

    Illustration 11	g03499456

12. Attach suitable lifting device to clean emissions module (20). The weight of clean emissions module (20) is approximately 230 kg (507 lb).
    Show/hide table

    Illustration 12	g03499486

13. Remove bolts (21).
    Show/hide table

    Illustration 13	g03499489

14. Remove bolts (22) and clean emissions module (20).

Installation Procedure

1. Install clean emissions module (20) in the reverse order of removal.

   1. Tighten clamp (16) to a torque of 35 ± 2 N·m (26 ± 2 lb ft).