1992/06/22 Caterpillar

Pin Installation on Side Pinned Tips and Adapters{6800,6805,6806,6808}

Usage:

GET Buckets, Scrapers, Landfill Compactors, Impact Rippers and D11N Tractor Single Shank Rippers

Pins for side pinned tips and adapters on bucket edges, scraper cutting edges, landfill compactor wheels, impact rippers, and D11N Tractor single shank rippers can work out of position if improperly installed.

For proper installation of these pins, always drive pin (1) in from the counterbore side of adapter (2).

Driving the pins in from the side opposite the counterbore can cause the retainer to stretch beyond its elastic limit and take a permanent set. This results in lower gripping force and can cause the tips to fall off the adapters.

NOTE: The counter bores on all bucket and scraper adapters are always on the right side of the adapter (facing the nose of the adapter) and on the left side of impact and D11N single shank rippers. The counterbores on landfill compactor tip adapters face toward the outside of the wheels.

Caterpillar Information System:

1992/06/22 New Radial Seal Air Filter Elements And Conversion Kits Available For Parts Service{1054,1051}

1992/06/15 New Exhaust Bellows Used In Turbocharger Group{1052}

1992/06/15 New Diaphragm Used In Fuel Ratio Control Groups{1278}

1992/06/15 4P6493 Governor Information Plate Available{7557}

1992/06/15 Battery Shelf Life Guidelines{1401}

1992/06/15 3F1006 Switch Assembly Now Serviced By Improved 3D9718 Switch Assembly; Procedure To Correctly Install Improved 3D9718 Switch Assembly{1435,1416,7429}

1992/05/25 New Components Help Prevent Air Leaks In Improved Fuel Ratio Control Groups{1278}

1992/05/25 Hydraulic Cylinder Seal Information Available{0374}

1992/05/25 O-Ring Material, Size, Cross-Reference, And New O-Ring Sizing Cone Information Available{0374}

1992/05/18 New And Remanufactured Fuel Injector Reference{1290}

1992/05/18 New Turbocharger Groups Used{1052}

1992/05/18 New Throttle Actuator In Governor Groups Improves Engine Stability{1289}

1992/06/22 Centrifugal Lube Filter Group Available{1328}

1992/06/22 New Training Material On 3306C And 3406C Truck Engines Available{0374,0375}

1992/06/29 Thinner Spacer Plates Available For Parts Service{1221}

1992/06/29 New Cylinder Heads Have Additional Coolant Passages{1101,1100}

1992/07/13 New Steel Plunger Used In Oil Filter Relief Valve Plunger; Use 2P4005 Oil Filters Instead Of 1R0716 Oil Filters{1315,1318}

1992/07/13 New Disconnect Switch Plate{1400,7557}

1992/07/20 New Hose Used In Engine Air Lines Groups{1058}

1992/07/20 Correction For Camshaft And Valve Seat Specifications{1210,1103}

1992/07/20 High Water Temperature Regulator May Help Prevent White Exhaust Smoke{1355}

1992/07/20 Clutch (PTO) Warranty On Morbark Industries Products Powered By Caterpillar Engines{7758}

1992/07/20 New Ways To Use The 6V2100 Multitach{0775,0781,0785}

1992/07/27 New Strap-Cable Used In Fastener Group{7553}