Correction to Specifications, "Pressure Switch (Axle Oil)" {1408}
- Load Haul Dump:
- R2900G (S/N: JLK1-UP)
The following information is an addition to the Specifications module for the new axle oil pressure switches. The new axle oil pressure switches are effective with JLK730-UP.
Pressure Switch (Axle Oil)
Part No.: 3E-7692
S/N: JLK1-UP
Show/hide table
Illustration 1 | g00879545 |
(1) Torque for the pressure switch ... 35 ± 3 N·m (26 ± 2 lb ft)
Maximum actuation pressure at -40°C to +121°C (-40°F to +250°F) ... 113 kPa (16 psi)
Deactuation pressure at -40°C to +121°C (-40°F to +250°F) ... 70 ± 20 kPa (10 ± 3 psi)
Current draw at 28 VDC ... 1.5 amperes
(2) Schematic symbol
Contacts 1 and 2 are normally open below the deactuation pressure of the pressure switch.
Caterpillar Information System:
966H Wheel Loader and 972H Wheel Loader Power Train Oil Filter (Power Train)
RM-300 Reclaimer Mixer Engine Supplement Fuel Priming Pump and Primary Filter (Water Separator) - Remove and Install
RM-500 Road Reclaimer/Soil Stabilizer Power Train Piston Motor (Front Propel) - Assemble
RM-500 Road Reclaimer/Soil Stabilizer Power Train Piston Motor (Front Propel) - Disassemble
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Fuel System Water Separator - Drain
2005/07/04 New Gaskets for the Turbocharger Oil Lines are Now Used {1052, 1307}
2005/07/18 Governor Cable Assembly Is Improved {1265}
RM-300 Reclaimer Mixer Engine Supplement Alternator - Remove and Install
RM-300 Reclaimer Mixer Machine Systems Relief Valve (Hood Tilt) - Test and Adjust
C6.6 Engines for Caterpillar Built Machines Cylinder Block
RM-300 Reclaimer Mixer Machine Systems Relief Valve (Parking Brake/Transmission Hydraulic Control) - Test and Adjust
AccuGradeTM - Grade Control System (GPS/ATS/Sonic/Cross Slope) Light Bar
2005/07/18 Correction to Specifications, "Pressure Switch (Residual Brake Oil)" {1408}
2005/07/25 Correction to Systems Operation Testing and Adjusting, "Axle Oil Cooler" {1365, 1408}
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Hydraulic Oil Sample - Obtain
RM-300 Reclaimer Mixer Machine Systems Sequence Valve - Test and Adjust
IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Power Train Oscillating Axle (Rear) - Remove
TH350B, TH360B, TH460B and TH560B Telehandlers Hydraulic System Lowering Control Pump (Electric) - If Equipped
IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Power Train Oscillating Axle (Rear) - Install
966H Wheel Loader and 972H Wheel Loader Power Train Modulating Valve (Transmission Clutch)
2006/01/02 Improvements to the Output Transfer Gear {3159}
RM-300 Reclaimer Mixer Machine Systems Gear Pump (Transmission) Flow - Test - Rotor Differential
2006/01/02 Improvements to the Output Transfer Gear {3159}
AP-800D and BG-230D Asphalt Pavers Lubricant Viscosities