Upper Conveyor Belt (Second Stage) Tension and Tracking - Adjust
注: 保持适当的传送带皮带张力是延长皮带寿命的必要条件。 正确的传送带皮带张力是传送带正常工作的必要条件。
正常使用时,传送带皮带会自然伸长。 调整皮带进行少量修正。 每调整一次都要检查操作。
Show/hide table
图 1 | g01216708 |
使用下列程序调整传送带皮带。 每次调整后,在皮带加载的情况下检查操作和轨迹。
如果皮带跑向左侧,伸长左侧张紧器。 如果皮带跑向右侧,伸长右侧张紧器。
- 松开张紧器 (3) 上的防松螺母 (1) 。
- 逆时针转动调整器 (2) 。
注: 当你逆时针旋转调整器 (2) 时,主动皮带轮向外伸出。
注: 转半圈调整皮带张紧器。
- 调整张紧器,直至皮带经过主动皮带轮的中心。
- 拧紧防松螺母 (1) 。
使用下列程序微调下传送带皮带。
如果皮带跑向左侧,伸长左侧张紧器。 如果皮带跑向右侧,伸长右侧张紧器。
- 松开张紧器 5 上的导轮防松螺母 (4) 。
Show/hide table
图 2 | g01216709 |
- 逆时针转动调整器 (6) 。
注: 转半圈调整张紧器。
- 调整张紧器,直至皮带经过导轮的中心。
- 拧紧防松螺母 (4) 。
- 在传送带两侧同时调整相同的数量。
注: 观察皮带的轨迹。 皮带将向需要额外张力的一侧运动。 拉紧这一侧的传送带。
检查上传送带的张力。 从传送带框架底部开始,下垂不应超过 152 mm (6 inch)。 如有必要,调整两个张紧器以便消除皮带的松弛
Caterpillar Information System:
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Hood and Engine Enclosure - Install
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Hood and Engine Enclosure - Remove
793D Off-Highway Truck/Tractor Electronic Control Module (Integrated Brake) - Remove and Install
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Refrigerant Compressor - Remove and Install
Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736} Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736}
785D OEM Off-Highway Truck Machine Systems Electronic Control Module (Power Train) - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Throttle Lock Switch Circuit - Test
R2900G Load Haul Dump Lifting and Tying Down the Machine
PM-201 Cold Planer Water Spray System Fluid Level - Check
PM-201 Cold Planer Water Spray System - Drain
PM-201 Cold Planer Steering Cylinder Ends - Lubricate
PM-201 Cold Planer Steering Linkage - Lubricate
3500 Engines Auxiliary Water Pump - Disassemble
3500 Engines Auxiliary Water Pump - Assemble
PM-201 Cold Planer Upper Conveyor Lift Cylinder Mount - Lubricate
PM-201 Cold Planer Track Tension - Check/Adjust
PM-201 Cold Planer Propel System Track
PM-201 Cold Planer Rotor Service Door Cylinder Pins - Lubricate
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Left Propel) - Remove
PM-201 Cold Planer Propel System Idlers (Track)
PM-201 Cold Planer Rotor Drive Belt - Inspect
PM-201 Cold Planer Propel System Hydraulic Tank
PM-201 Cold Planer Propel System Track Adjuster and Recoil
PM-201 Cold Planer Rotor Cutter Bits - Inspect/Replace