Electronic Control Module (Integrated Brake) - Remove and Install
拆卸步骤
开始:
- 拆下外盖。 请参阅拆解和组装, "外盖(发动机后部)- 拆卸和安装"。
- 将电源断路开关转至 OFF(断开)位置。
- 拆下螺栓 (1) 和模块组件 (2) 。
Show/hide table
图 1 | g01141269 |
- 断开线束组件 (3) 。
Show/hide table
图 2 | g01141272 |
- 拆下一体式制动器模块 (4) 。
安装步骤
- 安装一体式制动器模块 (4) 。
Show/hide table
图 3 | g01141272 |
- 连接线束组件 (3) 。
- 安装模块组件 (2) 和螺栓 (1) 。
Show/hide table
图 4 | g01141269 |
- 将电源断路开关转至 ON(接通)位置。
End By: 安装盖。 请参阅 拆解和组装, "外盖(发动机后部)- 拆卸和安装"。
Caterpillar Information System:
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Refrigerant Compressor - Remove and Install
Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736} Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736}
785D OEM Off-Highway Truck Machine Systems Electronic Control Module (Power Train) - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Throttle Lock Switch Circuit - Test
R2900G Load Haul Dump Lifting and Tying Down the Machine
PM-201 Cold Planer Water Spray System Fluid Level - Check
PM-201 Cold Planer Water Spray System - Drain
PM-201 Cold Planer Steering Cylinder Ends - Lubricate
PM-201 Cold Planer Steering Linkage - Lubricate
C11 and C15 Engines for Caterpillar Built Machines Compression Brake Solenoid Circuit - Test
PM-201 Cold Planer Legs (Struts) - Lubricate
PM-201 Cold Planer Rotor Service Door Pivot Pins - Lubricate
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Hood and Engine Enclosure - Remove
834H Wheel Dozer and 836H Landfill Compactor Engine Supplement Hood and Engine Enclosure - Install
PM-201 Cold Planer Upper Conveyor Belt (Second Stage) Tension and Tracking - Adjust
3500 Engines Auxiliary Water Pump - Disassemble
3500 Engines Auxiliary Water Pump - Assemble
PM-201 Cold Planer Upper Conveyor Lift Cylinder Mount - Lubricate
PM-201 Cold Planer Track Tension - Check/Adjust
PM-201 Cold Planer Propel System Track
PM-201 Cold Planer Rotor Service Door Cylinder Pins - Lubricate
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Left Propel) - Remove
PM-201 Cold Planer Propel System Idlers (Track)
PM-201 Cold Planer Rotor Drive Belt - Inspect