PM-201 Cold Planer Caterpillar


Stopping the Machine

Usage:

PM-201 PNM


注意

将机器停放在水平地面上。 如果必须停放在斜坡上,应牢固塞住履带。

除非在紧急状态,机器移动时,不要把停泊制动器合上。





    图 1g01140135

  1. 将推进操纵杆 (3) 移至中间位置。

  1. 接合驻车制动器 (1) 至 ON。

  1. 将洒水杆开关 (2) 和所有灯光开关都移至 OFF。

  1. 安装 支腿锁。

    参考参见操作和保养手册, "维修支架(支腿锁)"。

    注: 在严寒气候中,将机器停放在厚木板、石头或树枝上。 此动作可防止履带在寒冷天气中冻在地面上。 如果机器要在冰点温度下停放过夜,排空洒水系统。

Caterpillar Information System:

TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Front Idler and Track Adjuster - Install
RM-300 Soil Stabilizer Safety Messages
539 Knuckleboom Loader Cooling System Coolant Level - Check
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Right Drag Conveyor and Left Auger Conveyor) - Remove
793D Off-Highway Truck Battery Disconnect Switch
C15 and C18 Engines for Caterpillar Built Machines Engine Shutdown Switch Circuit - Test
C11 and C15 Engines for Caterpillar Built Machines Throttle Position Sensor Circuit - Test
R2900G Load Haul Dump Collet Pin Bolt Torque - Check
PM-201 Cold Planer Servicing the Rotor
PM-201 Cold Planer Service Support (Leg Lock)
PM-201 Cold Planer Hood Tilt
PM-201 Cold Planer Machine Interlocks
539 Knuckleboom Loader Delimber - Lubricate
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Lift Cylinder - Remove and Install
C7 and C9 Engines for Caterpillar Built Machines E096 High Fuel Pressure
3126B Engines Fuel System Pressure - Test
C11 and C15 Engines for Caterpillar Built Machines Engine Shutdown Switch Circuit - Test
785D OEM Off-Highway Truck Engine Shutdown Switch
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Sprocket - Remove and Install
785D OEM Off-Highway Truck Vital Information Management System (VIMS)
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Blade - Remove
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Blade - Install
PM-201 Cold Planer Stopping the Engine
PM-201 Cold Planer Shipping the Machine
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.