PM-201 Cold Planer Caterpillar


Servicing the Rotor

Usage:

PM-201 PNM
注: 要升起转筒维修门,必须满足下列条件:

  • 发动机转速为低怠速

  • 机器处于维修高度

  • 将维修支架(支腿锁)移至 锁止 (LOCKED) 位置。

  • 铲刀开关被移至 手动 (MANUAL) 位置。

  • 转筒控制开关处在断开 (OFF) 位置。

  • 坡度控制开关被移至断开 (OFF) 位置。




    图 1g01139134

  1. 使用门升高/降低开关。升起转筒维修门。

  1. 将门一直向上升起。



    图 2g01139144

  1. 降下门,确保门锁支撑住门的重量。

  1. 在转筒上进行维修。

    注: 当你维修转筒时,你应确认洒水系统是否工作正常。观察洒水系统的工作,确保水被直接喷洒在鼓和传送带上。




    图 3g01318180

  1. 维修完成后,升起门。使用提供的扶手将门锁保持在锁止位置以外。降下转筒门。

Caterpillar Information System:

PM-201 Cold Planer Service Support (Leg Lock)
PM-201 Cold Planer Hood Tilt
PM-201 Cold Planer Machine Interlocks
PM-201 Cold Planer Engine and Machine Warm-Up
PM-201 Cold Planer Engine Starting
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0353 - FMI 08
PM-201 Cold Planer Service Light Power Receptacle
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Operator Platform - Install
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Operator Platform - Remove
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0353 - FMI 01
C15 and C18 Engines for Caterpillar Built Machines Engine Temperature Sensor Open or Short Circuit - Test
2005/01/31 Improved Lifters are Now Used {1102, 1121, 1123}
R2900G Load Haul Dump Collet Pin Bolt Torque - Check
C11 and C15 Engines for Caterpillar Built Machines Throttle Position Sensor Circuit - Test
C15 and C18 Engines for Caterpillar Built Machines Engine Shutdown Switch Circuit - Test
793D Off-Highway Truck Battery Disconnect Switch
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Right Drag Conveyor and Left Auger Conveyor) - Remove
539 Knuckleboom Loader Cooling System Coolant Level - Check
RM-300 Soil Stabilizer Safety Messages
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Front Idler and Track Adjuster - Install
PM-201 Cold Planer Stopping the Machine
539 Knuckleboom Loader Delimber - Lubricate
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Lift Cylinder - Remove and Install
C7 and C9 Engines for Caterpillar Built Machines E096 High Fuel Pressure
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.