PM-201 Cold Planer Caterpillar


Engine and Machine Warm-Up

Usage:

PM-201 PNM



图 1g01139965


注意

在发动机机油压力显示在仪表上之前,保持发动机低速运转。 如果在15秒内没有显示,停止发动机。再次起动发动机前,查明原因 不这样做会造成发动机损坏。


  1. 选择较低的发动机转速。

  1. 检测监控系统面板。 如果检测出任何问题,进行必要的修正。 如果有任何 3 级警告,立即停止发动机。

  1. 让冷态发动机在低怠速运转至少五分钟,以便暖机。 操作附件控制装置,以便加快预热液压油和部件。

  1. 测试所有控制装置。 检查控制装置的工作是否正常。

  1. 将所有控制装置操作一遍。 使热机油在所有油缸和管路内循环。

    注: 遵循下列建议:

    • 在温度高于 0 °C (32 °F) 时使发动机运转 15 分钟。

    • 在温度低于 0 °C (32 °F) 时使发动机运转 30 分钟。

    • 在温度低于−18 °C (−0 °F) 时使发动机运转 30 分钟以上。

    • 如果液压功能迟缓,使发动机运转 30 分钟以上。

Caterpillar Information System:

PM-201 Cold Planer Engine Starting
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0353 - FMI 08
PM-201 Cold Planer Service Light Power Receptacle
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Operator Platform - Install
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Operator Platform - Remove
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0353 - FMI 01
C15 and C18 Engines for Caterpillar Built Machines Engine Temperature Sensor Open or Short Circuit - Test
2005/01/31 Improved Lifters are Now Used {1102, 1121, 1123}
2005/01/31 Improved Lifters are Now Used {1102, 1121, 1123}
PM-201 Cold Planer Plate Locations and Film Locations
PM-201 Cold Planer Capacities (Refill)
PM-201 Cold Planer Lubricant Viscosities
PM-201 Cold Planer Machine Interlocks
PM-201 Cold Planer Hood Tilt
PM-201 Cold Planer Service Support (Leg Lock)
PM-201 Cold Planer Servicing the Rotor
R2900G Load Haul Dump Collet Pin Bolt Torque - Check
C11 and C15 Engines for Caterpillar Built Machines Throttle Position Sensor Circuit - Test
C15 and C18 Engines for Caterpillar Built Machines Engine Shutdown Switch Circuit - Test
793D Off-Highway Truck Battery Disconnect Switch
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Right Drag Conveyor and Left Auger Conveyor) - Remove
539 Knuckleboom Loader Cooling System Coolant Level - Check
RM-300 Soil Stabilizer Safety Messages
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Front Idler and Track Adjuster - Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.