Assembly Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
9U-5717     |
Heat Shrink Tubing     |
1     |
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the seals, seal retainers, O-ring seals and backup rings for wear or for damage. Replace the components, if necessary.
Show/hide table
|
|
|
Illustration 1 | g01025501 |
Note: Steps 1 through 7 are for the assembly of the vibratory pump.
- Install the seal, seal retainer (29 ) , and seal (28) on end cover (27) .
Show/hide table
|
|
|
Illustration 2 | g01371061 |
- Install housing (23) and wear plate (26) on end cover (27) .
Show/hide table
|
|
|
Illustration 3 | g01025490 |
- Install gear assemblies (25) in housing (23) .
Show/hide table
|
|
|
Illustration 4 | g01371063 |
- Install wear plate (24) on housing (23) .
Show/hide table
|
|
|
Illustration 5 | g01025487 |
- Install seal (22) , seal retainer (21) , and seal (20) on the mounting flange.
Show/hide table
|
|
|
Illustration 6 | g01096268 |
- Install O-ring seal (19) on mounting flange (17) . Install lip seal (18) on the mounting flange, if the seal was previously removed.
Show/hide table
|
|
|
Illustration 7 | g01025483 |
- Apply Tooling (A) to shaft splines. Position mounting flange (17) on the housing. Install eight nuts (16) and six bolts (15) which hold the vibratory pump together.
Show/hide table
|
|
|
Illustration 8 | g01025480 |
Note: Steps 8 through 11 are for the assembly of the steering pump.
- Install seal (14) and seal retainer (13) in gear carrier (12) for each end of the gear assembly. Install the gear carriers on the gear assembly.
Show/hide table
|
|
|
Illustration 9 | g01025477 |
- Install seal (10) and O-ring seal (11) on housing (6) .
Show/hide table
|
|
|
Illustration 10 | g01025473 |
- Install O-ring seal (8) and backup ring (9) on relief valve (7) .
Show/hide table
|
|
|
Illustration 11 | g01025469 |
- Install the seal on the end cap (4) . Install relief valve (7) , gear assembly (5) , and end cap (4) on housing (6) .
Show/hide table
|
|
|
Illustration 12 | g01025467 |
- Position steering pump (2) on vibratory pump (1) . Install bolts (3) .
- Remove Tooling (A) from the shaft splines.
End By:
Install the vibratory and steering pump. Refer to Disassembly and Assembly , "Gear Pump (Steering and Vibratory) - Install".