Do not tilt the cab when occupied. Before tilting the cab remove all loose articles from the cab, secure all windows and emergency exits, and then close the cab and cab riser doors. Failure to do so can result in personal injury or damage to the machine. |
Illustration 1 | g00956743 |
Cab tilt pump (4) is located on the left side of the machine near the disconnect switches.
Reference: The engine hood must be opened in order to access the cab tilt pump. Refer to Operation and Maintenance Manual, "Tilt Hood" for more information.
Raising The Cab
Note: Secure any loose items inside the cab. Items may fall inside the cab. This may damage the controls. Secure the seat prior to raising the cab.
- Remove pump handle (1) from the inside of the cab.
- Remove two bolts and two pins (5) from the base of the cab.
- Rotate pump control (3) clockwise with the pump handle. Insert pump handle (1) into cab tilt pump (4) .
- Move pump handle (1) up and down in order to raise the cab.
- Continue to operate the pump handle until the cab is fully raised.
Note: As the cab tilts farther, the weight of the cab will allow the cab to continue tilting without pumping. To prevent the cab from tilting too fast, turn pump control (3) counterclockwise to the position for lowering when the cab reaches the halfway point.
Note: Cab support lever (6) will lock the cab into several positions.
Illustration 2 | g00931666 |
- Remove pump handle (1) .
Lowering The Cab
- Rotate pump control (3) counterclockwise in order to lower the cab.
- Insert pump handle (1) into cab tilt pump (4) .
- In order to release the cab support bar, pull out lock release (2). Continue to pull out the lock release and move pump handle (1) up and down. Continue to operate the pump handle until the cab is fully lowered.
Note: The cab may need to be raised slightly in order to release the lock.
- Install the two pins and the two bolts (5) .
- Remove pump handle (1). Store the pump handle on the inside of the cab.