PRODUCT SUPPORT PROGRAM FOR REPLACING THE CRANKCASE BREATHER GASKETS AND CLAMPS ON CERTAIN C175-20 GENERATOR SETS
Usage:
TEBE8857-00
Show/hide table
| 06Mar2019 |
A-80
Show/hide table
| Before/After | PRODUCT SUPPORT PROGRAM FOR REPLACING THE CRANKCASE BREATHER GASKETS AND CLAMPS ON CERTAIN C175-20 GENERATOR SETS |
|
| 1317 | PS46142 |
|
Show/hide table
| NOTE: | Caterpillar’s obligations under this Service Letter are subject to, and shall not apply in contravention of, the laws, rules, regulations, directives, ordinances, orders, or statutes of the United States, or of any other applicable jurisdiction, without recourse or liability with respect to Caterpillar. |
| NOTE: | This Program must be administered either before or after failure. In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS46142" as the Part Number and "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and "T" as the SIMS Description code. If administered after failure, use "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code. |
Show/hide table
| NOTE: | The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst. |
Show/hide table
Show/hide table
Show/hide table
Show/hide table
TERMINATION DATE |
| 31Mar2021 |
PROBLEM
Show/hide table
| The existing crankcase breather clamp can over compress the breather gasket resulting in gasket failure on certain C175-20 Generator Sets. If the existing Gasket fails it may result in an oil leak from the crankcase breather to housing joint. |
AFFECTED PRODUCT
Show/hide table
| Model | Identification Number |
| C175-20 | BXR01054-01064, 1067-1072, 1075, 1077-1078, 1080-1081, 1083-1087, 1089-1093, 1095, 1847-1849, 1851, 1855, 1867, 1870, 1873-1874, 1876 |
PARTS NEEDED
Show/hide table
Qty |
Part Number | Description |
| 4 | 4395502 | GASKET |
| 8 | 5324635 | CLAMP |
| In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 32% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer. |
||
ACTION REQUIRED
Show/hide table
| Replace the 383-6310 Clamp with 532-4635 Clamp that reduces the compression on the face seal. Refer to Disassembly and Assembly, RENR7466, Crankcase Breather - Remove and Install. |
Show/hide table
SERVICE CLAIM ALLOWANCES
Show/hide table
0-57 mo |
||||||
Show/hide table
| NOTE: This is a 0.5-hour job | ||||||
Show/hide table
PARTS DISPOSITION
Show/hide table
| Handle the parts in accordance with your Warranty Bulletin on warranty parts handling. |
Caterpillar Information System:
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE GASKET OF THE MAIN CONTROL VALVE ON CERTAIN 307.5, 308, AND 310 MINI HYDRAULIC EXCAVATORS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE GASKET OF THE MAIN CONTROL VALVE ON CERTAIN 307.5, 308, AND 310 MINI HYDRAULIC EXCAVATORS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 443-8879 SPACERS AND 443-8878 RINGS FROM DEALER PARTS STOCK INVENTORY PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 443-8879 SPACERS AND 443-8878 RINGS FROM DEALER PARTS STOCK INVENTORY
PRODUCT SUPPORT PROGRAM FOR THE TRANSMISSION ON CERTAIN 797F AND 797F XQ OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR THE TRANSMISSION ON CERTAIN 797F AND 797F XQ OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE FLOOD LAMP(S) ON CERTAIN 320, AND 323 EXCAVATORS PRODUCT SUPPORT PROGRAM FOR REPLACING THE FLOOD LAMP(S) ON CERTAIN 320, AND 323 EXCAVATORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE POSITION SENSING BUCKET CYLINDER ON CERTAIN 320E, 323E/F, 325F, 336D/E/F, 345D, 349D/D2, 349E/F, AND 352F EXCAVATORS, EQUIPPED WITH CAT GRADE CONTROL APPLICATION PRODUCT SUPPORT PROGRAM FOR REPLACING THE POSITION SENSING BUCKET CYLINDER ON CERTAIN 320E, 323E/F, 325F, 336D/E/F, 345D, 349D/D2, 349E/F, AND 352F EXCAVATORS, EQUIPPED WITH CAT GRADE CONTROL APPLICATION
PRODUCT SUPPORT PROGRAM FOR REMOVING THE POWER MODULE THAT SUPPLIES VOLTAGE TO THE FUEL CONTROL VALVE ON CERTAIN C175-16 MARINE AND PETROLEUM ENGINES PRODUCT SUPPORT PROGRAM FOR REMOVING THE POWER MODULE THAT SUPPLIES VOLTAGE TO THE FUEL CONTROL VALVE ON CERTAIN C175-16 MARINE AND PETROLEUM ENGINES
PRODUCT SUPPORT PROGRAM FOR REWORKING RADIATOR CORES ON CERTAIN 3512B GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REWORKING RADIATOR CORES ON CERTAIN 3512B GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE IMU SENSORS ON CERTAIN 320 AND 323 EXCAVATORS PRODUCT SUPPORT PROGRAM FOR REPLACING THE IMU SENSORS ON CERTAIN 320 AND 323 EXCAVATORS
PRODUCT SUPPORT PROGRAM FOR THE REAR COVER AND AIR FILTER SUPPORT ASSEMBLY ON CERTAIN XQC1200, AND XQC1600 POWER MODULES PRODUCT SUPPORT PROGRAM FOR THE REAR COVER AND AIR FILTER SUPPORT ASSEMBLY ON CERTAIN XQC1200, AND XQC1600 POWER MODULES
PRODUCT SUPPORT PROGRAM FOR REPLACING HIGH PRESSURE FUEL PUMP OIL SUPPLY HOSE ON CERTAIN C175-16 LOCOMOTIVE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING HIGH PRESSURE FUEL PUMP OIL SUPPLY HOSE ON CERTAIN C175-16 LOCOMOTIVE ENGINES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE DAMPER BOLTS ON CERTAIN C175-20 LOCOMOTIVE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE DAMPER BOLTS ON CERTAIN C175-20 LOCOMOTIVE ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR MEASURING AND ADJUSTING THE PUMP DRIVE BEARING PRELOAD ON CERTAIN 794 AC, 795F AC, 796 AC, 797F AND 798 AC OFF-HIGHWAY TRUCKS PRODUCT IMPROVEMENT PROGRAM FOR MEASURING AND ADJUSTING THE PUMP DRIVE BEARING PRELOAD ON CERTAIN 794 AC, 795F AC, 796 AC, 797F AND 798 AC OFF-HIGHWAY TRUCKS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REWORKING THE EARTH/GROUND CABLE ON CERTAIN C1.5 AND C2.2 GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REWORKING THE EARTH/GROUND CABLE ON CERTAIN C1.5 AND C2.2 GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE FUEL HEATER ON CERTAIN 3516C GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE FUEL HEATER ON CERTAIN 3516C GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR INSPECTING AND POSSIBLY REPLACING THE 532-8727 OR 20R-8235 ENGINE OIL PUMP ON CERTAIN 797F OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR INSPECTING AND POSSIBLY REPLACING THE 532-8727 OR 20R-8235 ENGINE OIL PUMP ON CERTAIN 797F OFF-HIGHWAY TRUCKS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 485-4705 LUBE FILTER ELEMENTS FROM DEALER PARTS STOCK PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 485-4705 LUBE FILTER ELEMENTS FROM DEALER PARTS STOCK
PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK PL542 OR PL240B CELLULAR RADIO SYSTEMS OR UPDATING SOFTWARE ON CERTAIN CATERPILLAR PRODUCTS PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK PL542 OR PL240B CELLULAR RADIO SYSTEMS OR UPDATING SOFTWARE ON CERTAIN CATERPILLAR PRODUCTS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE JACKET WATER RADIATORS ON CERTAIN XQC1600 POWER MODULES PRODUCT SUPPORT PROGRAM FOR REWORKING THE JACKET WATER RADIATORS ON CERTAIN XQC1600 POWER MODULES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE CRANKCASE BREATHER GASKET AND CLAMPS ON CERTAIN C175-16 AND C175-20 GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REPLACING THE CRANKCASE BREATHER GASKET AND CLAMPS ON CERTAIN C175-16 AND C175-20 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE MAIN CONTROL VALVE GASKET ON CERTAIN 307.5 AND 310 MINI HYDRAULIC EXCAVATORS PRODUCT SUPPORT PROGRAM FOR REPLACING THE MAIN CONTROL VALVE GASKET ON CERTAIN 307.5 AND 310 MINI HYDRAULIC EXCAVATORS
PRODUCT SUPPORT PROGRAM FOR INSPECTING THE HIGH PRESSURE FUEL PUMP ON CERTAIN 3512E PETROLEUM ENGINES, AND SPF743 TRAILER MOUNTED PUMPERS PRODUCT SUPPORT PROGRAM FOR INSPECTING THE HIGH PRESSURE FUEL PUMP ON CERTAIN 3512E PETROLEUM ENGINES, AND SPF743 TRAILER MOUNTED PUMPERS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE BOOM AND STICK ON CERTAIN 311F, 312F, 313F, 314F, 315F, 316F, 318F, 320, 323, 323F, 325F, 326D2, 326F, 330, 330D2, 330F, 335F, AND 336 EXCAVATORS PRODUCT SUPPORT PROGRAM FOR REWORKING THE BOOM AND STICK ON CERTAIN 311F, 312F, 313F, 314F, 315F, 316F, 318F, 320, 323, 323F, 325F, 326D2, 326F, 330, 330D2, 330F, 335F, AND 336 EXCAVATORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE BLOCK ASSEMBLY ON THE PUMP HEAD GROUP ON CERTAIN 374F AND 390F EXCAVATORS PRODUCT SUPPORT PROGRAM FOR REPLACING THE BLOCK ASSEMBLY ON THE PUMP HEAD GROUP ON CERTAIN 374F AND 390F EXCAVATORS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE FRONT AXLE STEERING CYLINDER BRACKET ON CERTAIN 794 AC AND 796 AC OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REWORKING THE FRONT AXLE STEERING CYLINDER BRACKET ON CERTAIN 794 AC AND 796 AC OFF-HIGHWAY TRUCKS