Air Inlet Shutoff - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Personal injury or death can occur from not following the proper procedure or the recommended tooling. To prevent the possibility of injury or death, follow the established procedure using the recommended tooling. |
Show/hide table
Before you remove the air intake shutoff, pull the trip knob on the air intake shutoff or press the emergency stop button in order to release the blade latch. If the blade latch is released after the air intake shutoff is removed, serious personal injury can result. |
- Pull or press the emergency stop button in order to release the blade latch on the air inlet shutoff.
Show/hide table
Illustration 1 g03836959 - Remove bolts (1) and (2) and remove elbow (3). Check the gaskets and replace the gaskets, if necessary.
Show/hide table
Illustration 2 g03836960 - Disconnect hose assembly (4). Remove bolts (5) and remove air inlet shutoff (6). Check the gasket and replace the gasket, if necessary.
- Install air inlet shutoff (6) in the reverse order of removal.
Caterpillar Information System:
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
G3606 and G3608 Engines Aftercooler - Disassemble
3512C and 3516C Industrial Engines Air Lines
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Engine Oil Filter
3500 Industrial Engines Fuel Injector Mechanism
Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490} Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490}
C9.3 Marine Engine Fuel Pressure Sensor - Remove and Install
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C9.3 Marine Engine Inlet Manifold Temperature Sensor - Remove and Install
C9.3 Marine Engine Inlet Manifold Pressure Sensor - Remove and Install
C9.3 Marine Engine Belt Tensioner - Remove and Install
C9.3 Marine Engine Engine Control Module - Remove and Install
3512C and 3516C Industrial Engines Air Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Water Lines
PM820, PM822, and PM825 Cold Planer Machine Interlocks