Inlet Manifold Temperature Sensor - Remove and Install
- Disconnect harness assembly (1) and remove inlet manifold temperature sensor (2).
Show/hide table
| |
| Illustration 1 | g03836962 |
|
Typical example. | |
- Install inlet manifold temperature sensor (2) in the reverse order of removal.
- Tighten inlet manifold temperature sensor (2) to a torque of
20 ± 3 N·m (177 ± 27 lb in) .
- Tighten inlet manifold temperature sensor (2) to a torque of
Caterpillar Information System:
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install
C9.3 Marine Engine Fuel Pressure Sensor - Remove and Install
C280-08 Tier 4 Engine Air Inlet Shutoff - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
G3606 and G3608 Engines Aftercooler - Disassemble
3512C and 3516C Industrial Engines Air Lines
C9.3 Marine Engine Inlet Manifold Pressure Sensor - Remove and Install
C9.3 Marine Engine Belt Tensioner - Remove and Install
C9.3 Marine Engine Engine Control Module - Remove and Install
3512C and 3516C Industrial Engines Air Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Water Lines
PM820, PM822, and PM825 Cold Planer Machine Interlocks
C9.3 Marine Engine Electric Starting Motor - Remove and Install - 24V Electric
3406E Engine Cylinder Head - Install
C9.3 Marine Engine Electric Starting Motor - Remove and Install - Dual Start - 24V Electric and Air Start
C2.2 Engines For Caterpillar Built Machines Sensor Supply - Test