Electric Starting Motor - Remove and Install - Dual Start - 24V Electric and Air Start
Show/hide table
 |
|
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury. |
Show/hide table
|
|
Personal injury can result from failure to disconnect the battery. First, disconnect the negative battery cable. Then, disconnect the positive battery cable. A positive power lead can cause sparks if the battery is not disconnected. Sparks can possibly result in battery explosion or fire. |
- Disconnect the batteries.
- Shut OFF the pressurized air supply or gas supply. Purge the pressurized air from the hose assemblies, tube assemblies, and the air starting motor.
Show/hide table
Illustration 1 g03837228 - Remove harness assembly (1), harness assembly (2), and harness assembly (3).
Show/hide table
Illustration 2 g03837236 - Remove bolts (5) and electric starting motor (4).
Show/hide table
Illustration 3 g03837240 - Disconnect harness assembly (6).
- Remove bolts (8) and air starting motor (7).
- Install air starting motor (7) and electric starting motor (4) in the reverse order of removal.
Caterpillar Information System:
3406E Engine Cylinder Head - Install
C9.3 Marine Engine Electric Starting Motor - Remove and Install - 24V Electric
PM820, PM822, and PM825 Cold Planer Machine Interlocks
3512C and 3516C Industrial Engines Water Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Air Lines
C9.3 Marine Engine Engine Control Module - Remove and Install
C9.3 Marine Engine Belt Tensioner - Remove and Install
C9.3 Marine Engine Inlet Manifold Pressure Sensor - Remove and Install
C9.3 Marine Engine Inlet Manifold Temperature Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C2.2 Engines For Caterpillar Built Machines Sensor Supply - Test
C9.3 Marine Engine Electric Starting Motor - Remove and Install - 12V Electric
G3606 and G3608 Engines Aftercooler - Assemble
PM820, PM822, and PM825 Cold Planer Track Tension - Check/Adjust
C9.3 Marine Engine Heat Exchanger - Remove and Install
C7 and C9 Industrial Engines Component Location
C7 and C9 Industrial Engines Configuration Parameters
C7 and C9 Industrial Engines Coolant Temperature Is High
C7 and C9 Industrial Engines Fuel Pressure Is High
G3606 and G3608 Engines Turbocharger - Remove
C7 and C9 Industrial Engines Fuel Pressure Is Low
C7 and C9 Industrial Engines Intake Manifold Air Temperature Is High