Fuel Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines. |
Show/hide table
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death. |
- Disconnect harness assembly (1).
Note: If necessary remove the drip tray.
- Remove fuel pressure post filter sensor (2) and fuel pressure prefilter sensor (3).
Show/hide table
Illustration 2 g03836832 - Disconnect harness assembly (5).
- Remove fuel pressure post filter sensor (4).
Show/hide table
Illustration 1 | g03836818 |
- Install fuel pressure post filter sensor (4), fuel pressure prefilter sensor (3), and fuel pressure post filter sensor (2) in the reverse order of removal.
- Tighten fuel pressure post filter sensor (4), fuel pressure prefilter sensor (3), and fuel pressure post filter sensor (2) to a torque of
10 ± 2 N·m (86 ± 18 lb in) .
- Tighten fuel pressure post filter sensor (4), fuel pressure prefilter sensor (3), and fuel pressure post filter sensor (2) to a torque of
Caterpillar Information System:
C280-08 Tier 4 Engine Air Inlet Shutoff - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
G3606 and G3608 Engines Aftercooler - Disassemble
3512C and 3516C Industrial Engines Air Lines
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Engine Oil Filter
3500 Industrial Engines Fuel Injector Mechanism
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C9.3 Marine Engine Inlet Manifold Temperature Sensor - Remove and Install
C9.3 Marine Engine Inlet Manifold Pressure Sensor - Remove and Install
C9.3 Marine Engine Belt Tensioner - Remove and Install
C9.3 Marine Engine Engine Control Module - Remove and Install
3512C and 3516C Industrial Engines Air Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Fuel Injection Lines
3512C and 3516C Industrial Engines Water Lines
PM820, PM822, and PM825 Cold Planer Machine Interlocks
C9.3 Marine Engine Electric Starting Motor - Remove and Install - 24V Electric