Turbocharger
Show/hide table
图 1 | g00757973 |
Show/hide table
图 2 | g00757964 |
(1) 螺栓
在螺栓 (1) 的螺纹上涂抹 5P-3931 防粘结剂 。
(2) 涡轮增压器 排气
- 拧紧夹紧螺栓。
扭矩 ... 9.5 ± 1.0 N·m (84 ± 9 lb in)
- 用软面锤轻轻敲打夹紧螺栓周围。
- 再次拧紧夹紧螺栓。
扭矩 ... 9.5 ± 1.0 N·m (84 ± 9 lb in)
(3) 压缩机壳体的夹紧螺栓和 (4) 涡轮机壳体的夹紧螺栓。
- 拧紧夹紧螺栓。
扭矩 ... 14.0 ± 1.5 N·m (10 ± 1 lb ft)
- 用软面锤轻轻敲打螺栓周围。
- 再次拧紧螺栓。
扭矩 ... 14.0 ± 1.5 N·m (10 ± 1 lb ft)
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Tuning OP-11
3500B Engines for Caterpillar Built Power Modules Turbocharger
G3606 and G3608 Engines Connecting Rod Bearings - Remove and Install
3500B Engines Turbocharger
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
G3606 and G3608 Engines Magneto Interface - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3406E Generator Set Engines Control Panel
3116 Truck Engine Cold Weather Operation
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
12H, 140H and 160H Motor Graders Power Train Final Drive - Disassemble
3406E Generator Set Engines Model View Illustrations
3500 Engines Exhaust Manifold
120H and 135H Motor Graders Power Train Final Drive - Assemble
G3500 Engines Engine Oil and Water Pump Drive - Remove
G3500 Engines Engine Oil and Water Pump Drive - Install
G3500 Engines Rocker Shaft and Push Rod - Remove
G3500 Engines Rocker Shaft and Push Rod - Install
3406E and 3456 Generator Set Engines Rocker Arm and Shaft - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0001 - FMI 05 Injector Cylinder 1 open circuit
3512B and 3516B Engines Air Inlet and Exhaust Lines
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove