Rocker Shaft and Push Rod - Remove
Start By:
- Remove the valve cover and the spark plug. Refer to Disassembly and Assembly, "Valve Cover and Spark Plug - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) and remove rocker shaft (2) from the valve cover base.
Show/hide table
Illustration 2 g00587021 Note: Place an identification mark on each pushrod in order to identify the proper location in the engine.
- Remove pushrods (4) from the valve lifters.
- Remove valve bridges (3).
Show/hide table
Illustration 1 | g00587020 |
Caterpillar Information System:
G3500 Engines Engine Oil and Water Pump Drive - Install
G3500 Engines Engine Oil and Water Pump Drive - Remove
120H and 135H Motor Graders Power Train Final Drive - Assemble
3500 Engines Exhaust Manifold
3406E Generator Set Engines Model View Illustrations
12H, 140H and 160H Motor Graders Power Train Final Drive - Disassemble
3508B Engine for Caterpillar Built Machines Turbocharger
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Tuning OP-11
3500B Engines for Caterpillar Built Power Modules Turbocharger
G3606 and G3608 Engines Connecting Rod Bearings - Remove and Install
3500B Engines Turbocharger
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
G3500 Engines Rocker Shaft and Push Rod - Install
3406E and 3456 Generator Set Engines Rocker Arm and Shaft - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0001 - FMI 05 Injector Cylinder 1 open circuit
3512B and 3516B Engines Air Inlet and Exhaust Lines
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0001 - FMI 06 Injector Cylinder 1 short
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0002 - FMI 05 Injector Cylinder 2 open circuit
3406E and 3456 Generator Set Engines Rocker Arm and Shaft - Install
G3500 Engines Engine Oil Filter Housing - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0002 - FMI 06 Injector Cylinder 2 short
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0003 - FMI 05 Injector Cylinder 3 open circuit
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0003 - FMI 06 Injector Cylinder 3 short