Cab Tilting
Show/hide table
 | |
| Illustration 1 | g00808783 |
Show/hide table
 | |
| Illustration 2 | g00808883 |
- Remove bolt (2) and pin (3) from ballast (1). With a lifting device, carefully lower ballast (1) to rest on a wood block.
- Attach lifting chains (4) and a hoist to the top of the cab assembly.
- Remove the bolt and nut (5) and remove the bolts and nuts (6) from each side that holds the cab to the frame.
Show/hide table
 | |
| Illustration 3 | g00808884 |
- Disconnect cable (7) from the governor. Loosen jam nut (8). Remove the cable from bracket (9) .
Show/hide table
 | |
| Illustration 4 | g00808885 |
- Use a hoist in order to raise the cab. Raise the cab until the two holes are aligned. Install one bolt (10) and wood block (11) on each side of the cab.
Show/hide table
 | |
| Illustration 5 | g00808886 |
Note: In order to lower the cab, reverse the procedure for tilting the cab.
Caterpillar Information System:
2001/06/25 Correction to Parts Manual for Harvester Heads {5051}
TK1051 Track Feller BuncherEngine Supplement Refrigerant Condenser - Remove and Install
TK1051 Track Feller Buncher Machine Systems Stick - Remove
CP-433E, CS-423E and CS-433E Vibratory Compactors Engine Supplement Battery - Remove and Install
824G Series II Wheel Dozer, 825G Series II Soil Compactor and 826G Series II Landfill Compactor Power Train Differential and Bevel Gear
8-16B Extend-A-Mat Screed Thickness Control Screw Adjustment
966H Wheel Loader and 972H Wheel Loader Electrohydraulic System Machine Preparation for Troubleshooting
8-16B Extend-A-Mat Screed Auger Extension Installation
988G Wheel Loader Electrohydraulic System Visual Inspection
8-16B Extend-A-Mat Screed Extension Installation
CP-663E, CS-663E and CS-683E Vibratory Compactors Machine Systems Refrigerant Accumulator - Remove and Install
CP-663E, CS-663E and CS-683E Vibratory Compactors Machine Systems Refrigerant Condenser - Remove and Install
725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System Transmission Fill - Calibrate - Using the Caterpillar Monitoring System
TH210 and TH215 Telehandlers Steering Control
TH210 and TH215 Telehandlers Steering Mode Control
TH210 and TH215 Telehandlers Lockout Control
TH210 and TH215 Telehandlers Longitudinal Stability Indicator
8-16B Extend-A-Mat Screed Adjustments While Paving
8-16B Extend-A-Mat Screed Screed Plate Leveling
2001/07/02 Special Instruction, REHS0986, "Procedure for the Removal of Bolts That Are Used for Shipping on Differentials" is Now Available {3258}
CP-433E, CS-423E and CS-433E Vibratory Compactors Engine Supplement Electric Starting Motor - Remove and Install
TK1051 Track Feller BuncherEngine Supplement Preparation for Disassembly
8-16B Extend-A-Mat Screed Operating Principles
3176C and 3196 Engines for Caterpillar Built Machines 5 Volt Engine Pressure Sensor Supply Circuit - Test