Engine Valve Lash - Check
This maintenance is recommended by Caterpillar as part of a lubrication and preventive maintenance schedule in order to help provide maximum engine life.
Show/hide table
| NOTICE |
|---|
Only qualified service personnel should perform this maintenance. Refer to the Service Manual or your Caterpillar dealer for the complete valve lash adjustment procedure. Operation of Caterpillar engines with improper valve adjustments can reduce engine efficiency. This reduced efficiency could result in excessive fuel usage and/or shortened engine component life. |
Caterpillar Information System:
CB-535B Vibratory Compactor Engine Oil and Filter - Change
CB-535B Vibratory Compactor Engine Oil Sample - Obtain
CB-535B Vibratory Compactor Engine Oil Level - Check
1999/12/06 New Service Magazine Format {0374, 1000, 7000}
CB-535B Vibratory Compactor Engine Mounts - Inspect
2000/01/10 Oil Filler Cap is Now Attached with a Lanyard {1316}
CB-535B Vibratory Compactor Engine Crankcase Breather - Clean - Engine Crankcase Breather Hose
CB-535B Vibratory Compactor Engine Air Filter Service Indicator - Inspect
CB-535B Vibratory Compactor Engine Air Filter Secondary Element - Replace
CB-535B Vibratory Compactor Engine Air Filter Primary Element - Clean/Replace
CP-433C, CS-431C and CS-433C Paving Compactors Fuel System Water Separator - Drain
CB-535B Vibratory Compactor Drum Scrapers - Inspect/Adjust/Replace
CB-535B Vibratory Compactor Engine Water Pump - Inspect
CB-535B Vibratory Compactor Drum Offset Control
3054B Industrial Engine Engine Oil Filter Base - Remove
3054B Industrial Engine Engine Oil Filter Base - Install
3054B Industrial Engine Engine Oil Filter Base - Disassemble
TH62, TH63, TH82 and TH83 Telehandlers Braking System Service Brake Air - Purge
1999/12/20 Change to Tightening Procedure for Cylinder Head Bolts in Specifications, RENR1217 and Specifications, SENR5182 {1100}
TH62, TH63, TH82 and TH83 Telehandlers Hydraulic System Towing Hitch System - If Equipped
2000/02/21 New Air Cleaner Support and Exhaust Tube Bracket Available for 24H Motor Grader, D10R Track-Type Tractor, and the 651E and 657E Wheel Tractor Scrapers {1051, 1061}
2000/01/03 Locations Where New Tube Assemblies Are Used {1274}
2000/02/07 New Procedure to Test DASA 280C on Excavators With the HH65 Harvester Head {7610, 7620}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0261 FMI 13 Engine Timing Calibration required