Engine Mounts - Inspect
Open the engine compartment.
There are four engine mounts. There is one engine mount at each corner of the engine.
Engine vibration can be caused by improper mounting of the engine. Engine vibration can be caused by loose engine mounts or deteriorated engine mounts.
Inspect the engine mounts for deterioration.
Replace any engine mount that is deteriorated.
Inspect the engine mounts for correct bolt torque.
Tighten the mounts if the mounts are loose.
Close the engine compartment.
Caterpillar Information System:
2000/01/10 Oil Filler Cap is Now Attached with a Lanyard {1316}
CB-535B Vibratory Compactor Engine Crankcase Breather - Clean - Engine Crankcase Breather Hose
CB-535B Vibratory Compactor Engine Air Filter Service Indicator - Inspect
CB-535B Vibratory Compactor Engine Air Filter Secondary Element - Replace
CB-535B Vibratory Compactor Engine Air Filter Primary Element - Clean/Replace
CP-433C, CS-431C and CS-433C Paving Compactors Fuel System Water Separator - Drain
CB-535B Vibratory Compactor Drum Scrapers - Inspect/Adjust/Replace
CB-535B Vibratory Compactor Directional Turn Signal and Hazard Flasher Control - If Equipped
TH62, TH63, TH82 and TH83 Telehandlers Braking System Brakes
D350E Series II, D400E Series II and D400E Series II Ejector Articulated Trucks Braking System Service Brake System
988G Wheel Loader Power Train Final Drive and Wheel
966G Wheel Loader and 972G Wheel Loader Power Train Forward High Speed Lockout - Program
1999/12/06 New Service Magazine Format {0374, 1000, 7000}
CB-535B Vibratory Compactor Engine Oil Level - Check
CB-535B Vibratory Compactor Engine Oil Sample - Obtain
CB-535B Vibratory Compactor Engine Oil and Filter - Change
CB-535B Vibratory Compactor Engine Valve Lash - Check
CB-535B Vibratory Compactor Engine Water Pump - Inspect
CB-535B Vibratory Compactor Drum Offset Control
3054B Industrial Engine Engine Oil Filter Base - Remove
3054B Industrial Engine Engine Oil Filter Base - Install
3054B Industrial Engine Engine Oil Filter Base - Disassemble
TH62, TH63, TH82 and TH83 Telehandlers Braking System Service Brake Air - Purge
1999/12/20 Change to Tightening Procedure for Cylinder Head Bolts in Specifications, RENR1217 and Specifications, SENR5182 {1100}