Removal Procedure
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
- Use the following procedure to release the pressure in the hydraulic system:
- Lower the attachments to the ground.
- Shut off the engine.
- Move the control levers through the full travel distance of the levers. This will relieve any pressure in the pilot system.
- Slowly loosen the filler cap on the hydraulic oil tank in order to release the pressure.
- Tighten the filler cap on the hydraulic oil tank.
- The pressure in the hydraulic system has now been relieved. Lines and components can now be removed.
- Attach a lifting strap to jib boom cylinder (1) and use a suitable lifting device to support the cylinder.
Note: Put identification on all lines, hoses, wires, and tubes for installation purposes. Install a cap or plug on all lines, hoses, and tubes that are disconnected. The caps and/or plugs prevent the loss of fluid and contaminants cannot enter the system.
 | |
| Illustration 1 | g00637443 |
- Attach a lifting strap to jib boom (2) and use a suitable lifting device to support the boom.
- Disconnect hose assemblies (3) and (4) .
| NOTICE |
|---|
Be sure that the engine is off. Move the control lever in order to be sure that the weight of the jib boom is being supported by the lifting device. Move the control lever back and forth from one side to the other in order to release the pressure in the hydraulic system. Loosen the filler cap slowly in order to release the pressure in the hydraulic tank. |
 | |
| Illustration 2 | g00637444 |
- Remove bolt (6) and the retainer. Remove pin (5) .
 | |
| Illustration 3 | g00637445 |
- Remove bolt (8) and the retainer. Remove pin (7) and jib boom cylinder (1). The approximate weight of the cylinder is 77 kg (170 lb).
 | |
| Illustration 4 | g00637447 |
Installation Procedure
- Attach a lifting strap to jib boom (2) and support the boom in position for the installation of jib boom cylinder (1) .
 | |
| Illustration 5 | g00637905 |
- Attach a lifting strap to jib boom cylinder (1) and put the cylinder in position for installation. The approximate weight of the jib boom cylinder is 77 kg (170 lb).
- Install pin (7), the retainer, and bolt (8) .
| | |
| Illustration 6 | g00637447 |
- Install pin (5), the retainer, and bolt (6) .
| | |
| Illustration 7 | g00637445 |
- Connect hose assemblies (3) and (4) .
| | |
| Illustration 8 | g00637444 |
- Check the oil level in the hydraulic tank.
Note: Refer to the Operation and Maintenance Manual, SEBU7001, "Hydraulic System Oil Level - Check" for the correct procedure.