154-5465 Front Axle
 | |
| Illustration 1 | g00519711 |
(1) Do not use lubrication on the pin during installation. Diameter of 112-9629 Pin ... 55.00 + 0.00 - 0.05 mm (2.165 + 0.00 - 0.002 inch)
(2) Use the following washers in order to attain a maximum gap of 0.8 mm (0.032 inch).
(3) Thickness of 165-8996 Thrust Washers ... 5.00 ± 0.25 mm (0.197 ± 0.010 inch)
(4) Assemble the 154-5405 Seals with the flat surfaces toward the outside. Apply ten weight oil to the exterior seal surfaces before installation.
(5) During installation, do not use lubrication on the bearings. Inside diameter of 154-5404 Bearings after installation ... 55.195 ± 0.025 mm (2.1730 ± 0.0010 inch)
(6) Tighten 8T-8549 Locknut to the following torque. ... 100 ± 20 N·m (73.7560 ± 14.7512 lb ft)
(7) Apply grease to the bearings before you assemble the bearings on the spindle.
(8) Tighten 8T-3990 Nut to 75 N·m (55.3170 lb ft). Turn the nut counterclockwise to the nearest locking hole. Install 3B-4631 Cotter in the locking hole.
(9) Diameter of 160-1014 Pins ... 40 + 0.00 - 0.05 mm (1.5748 + 0.00 - 0.0020 inch)
(10) Tighten 6V-7744 Locknut to the following torque. ... 55 ± 10 N·m (40.5658 ± 7.3756 lb ft)
(11) Inside diameter of 9R-1917 Sleeve Bearings after installation ... 40.153 ± 0.043 mm (1.5808 ± 0.0017 inch)