Removal Procedure
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Open the engine hood.
- Loosen clamp (1) and remove hose (2) from water separator (3) .
Illustration 1 | g00498406 |
- Loosen clamp (5) and remove hose (6) from water separator (3) .
Illustration 2 | g00498411 |
- Remove two bolts and washers (4) .
- Remove water separator (3) from the machine.
Installation Procedure
- Install water separator (3) to the machine.
Illustration 3 | g00498411 |
- Install washers and two bolts (4) .
- Install hose (6) to water separator (3) and tighten clamp (5) .
- Install hose (2) to water separator (3) and tighten clamp (1) .
Illustration 4 | g00498406 |