Caterpillar products such as engines, transmissions, and major attachments that are not designed for an operator to ride are identified by Serial Numbers.
For quick reference, record the identification numbers in the spaces that are provided below the illustration.
Product Identification Number (PIN)
Illustration 1 | g00791611 |
The PIN plate is located on the frame in front of the front left tire. |
- Model Number____________________
- Machine PIN____________________
Optional Plate for the European Union
Illustration 2 | g00490771 |
If the machine is equipped with the optional plate for the European Union, the plate will be located next to the door on the left side of the cab. |
If the machine is equipped for the European Union, this plate will be attached. This plate will contain the following information.
PIN____________________
Model____________________
Power (kW)____________________
Weight (kg)____________________
Note: If the Year Of Manufacture is not located on the CE Plate, this information will be located on a plate inside the cab.
Illustration 3 | g00524671 |
Service Information Number (SIN)____________________
Illustration 4 | g00524672 |
Transmission Serial Number____________________
Illustration 5 | g00524673 |
Engine Serial Number____________________
Illustration 6 | g00794684 |
Dump Body Serial Number____________________
The following information is stamped on the component.
Torque Converter Serial Number____________________
This certification plate is located outside the cab on the right side of the ROPS.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification. |
Illustration 7 | g00100417 |
Earlier Machines |
Illustration 8 | g01125202 |
Later Machines |
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.
If equipped, this film is located on the right side of the cab behind the right door.
Illustration 9 | g01015551 |
A typical example of this film is shown. Your machine may have a different value. |
If equipped, the certification film is used to verify the environmental sound certification of the machine to the requirements of the European Union. The value that is listed on the label indicates the guaranteed exterior sound power level LWA at the time of manufacture for the conditions that are specified in "2000/14/EC".