Certain Air Dryers Should be Removed From Dealer Inventory Caterpillar


Certain Air Dryers Should be Removed From Dealer Inventory

Usage:

Certain Air Dryers Should be Removed From Dealer Inventory

CONFIDENTIAL TIBU2653-00

TECHNICAL INFORMATION BULLETIN

December 18, 2002

 

All Caterpillar Products

Component Code(s)

4285

SUBJECT:

Certain Air Dryers Should be Removed From Dealer Inventory

PROBLEM:

The supplier of these air dryers is investigating possible problems with the housings on these Air Dryers:

6G-9970

8V-0769

9V-9118

2G-2159

It is recommended at this time that all Dealer inventories of these air dryers be checked for the date codes listed below. If one is found, remove it from inventory until further notice. Further information will follow.

If one has been installed on a machine, leave it on the machine. Further information will follow.

SOLUTION:

For those air dryers, with the date code listed below, already installed on vehicles, further information will follow.

 

 

View of date code tag (1) on the bottom of the assembly.

  1. Date Code Tag
  2. Part Number Code
  3. Date Code

Code (2)

Part Number

288595

2G-2159

289008

184-1614

102351

6G-9970

102595

8V-0769

 

 

If any of the following date codes appear, hold on to that component for further information. Pay particular attention to the 2nd, 5th and 6th characters.

Code (3)

XLXX01X

XMXX01X

XAXX02X

XBXX02X

XCXX02X

XDXX02X

XEXX02X

 

 

COPYRIGHT 2002 CATERPILLAR
ALL RIGHTS RESERVED

Caterpillar Information System:

There Is a New Shipping Configuration for the 777D There Is a New Shipping Configuration for the 777D
The New Body Up Switch Is Available For Quarry and Construction Trucks The New Body Up Switch Is Available For Quarry and Construction Trucks
A Pipe Assembly and A Handhold Have Been Removed from the Walkway Group A Pipe Assembly and A Handhold Have Been Removed from the Walkway Group
Additions to Service Maintenance Interval for Suspension Cylinders on Off-Highway Trucks Additions to Service Maintenance Interval for Suspension Cylinders on Off-Highway Trucks
2G-9000 RECEIVER USED IN THE WIGGINS FUEL SYSTEM MAY NOT FUCNTION PROPERLY 2G-9000 RECEIVER USED IN THE WIGGINS FUEL SYSTEM MAY NOT FUCNTION PROPERLY
USE PROPER LUBRICANT WHEN ASSEMBLING THE AIR INDUCTION SYSTEM USE PROPER LUBRICANT WHEN ASSEMBLING THE AIR INDUCTION SYSTEM
THE 171-1008 LOCKUP CLUTCH VALVE SHOULD BE MONITORED AFTER A TRANSMISSION FAILURE HAS OCCURED THE 171-1008 LOCKUP CLUTCH VALVE SHOULD BE MONITORED AFTER A TRANSMISSION FAILURE HAS OCCURED
STEERING PIN STRAP INSTALLATION STEERING PIN STRAP INSTALLATION
The Aftercooler (ATAAC) May Be Improperly Installed on 773E Off-Highway Trucks The Aftercooler (ATAAC) May Be Improperly Installed on 773E Off-Highway Trucks
INTERIM CLAMP STRATEGY FOR 4P-5212 HOSES INTERIM CLAMP STRATEGY FOR 4P-5212 HOSES
THE 8D-4755 REGULATOR MAY BE INSTALLED INCORRECTLY ON CERTAIN OFF-HIGHWAY TRUCKS THE 8D-4755 REGULATOR MAY BE INSTALLED INCORRECTLY ON CERTAIN OFF-HIGHWAY TRUCKS
Surface Cracks Found In 138-7574 Link Bracket Surface Cracks Found In 138-7574 Link Bracket
The 192-7887 Guard That is Under the Right Hand Platform has been Removed The 192-7887 Guard That is Under the Right Hand Platform has been Removed
185-3628 ; 185-3629 STEERING SHAFTS MUST BE INSPECTED PRIOR TO INSTALLATION 185-3628 & 185-3629 STEERING SHAFTS MUST BE INSPECTED PRIOR TO INSTALLATION
HOIST CONTROL VALVE ELECTRICAL CONNECTORS MAY GET MATCHED INCORRECTLY HOIST CONTROL VALVE ELECTRICAL CONNECTORS MAY GET MATCHED INCORRECTLY
777D Final Drive Wear on bearing and/or Thrust Plate 777D Final Drive Wear on bearing and/or Thrust Plate
Use Only 6 Micron Filters on the Transmissions for the Newer Motor Graders Use Only 6 Micron Filters on the Transmissions for the Newer Motor Graders
Requesting Information on Motor Grader Films Requesting Information on Motor Grader Films
New Method for Shipping Mirrors for the Motor Graders New Method for Shipping Mirrors for the Motor Graders
Drive Shaft U-Joint Bolts May Not Have the Proper Torque on Certain Motor Graders Drive Shaft U-Joint Bolts May Not Have the Proper Torque on Certain Motor Graders
New Method of Engaging the Parking Brake on Motor Graders New Method of Engaging the Parking Brake on Motor Graders
Inspection of the Gear Pump for the Hoist on the 797 Off-Highway Trucks is Required Inspection of the Gear Pump for the Hoist on the 797 Off-Highway Trucks is Required
HYDRAULIC TANK FILLER TUBE STRAINER MAY RUST HYDRAULIC TANK FILLER TUBE STRAINER MAY RUST
Support Bracket for the Rotary Beacon Interferes With the Cab Support Bracket for the Rotary Beacon Interferes With the Cab
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.