PRODUCT SUPPORT PROGRAM FOR REWORKING THE DRIVE SHAFT (REAR) BOLTS ON CERTAIN R1600G LOAD HAUL DUMP MACHINES
Usage:
TEBE0464-00
Show/hide table
| 30Sep2013 |
U-459
A-316
D-382
O-386
Show/hide table
| Before/After | PRODUCT SUPPORT PROGRAM FOR REWORKING THE DRIVE SHAFT (REAR) BOLTS ON CERTAIN R1600G LOAD HAUL DUMP MACHINES |
|
| 3253 | PS44034 |
|
Show/hide table
| NOTE: | This Program must be administered either before or after failure. In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS44034" as the Part Number and "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and "T" as the SIMS Description code. If administered after failure, use "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code. |
Show/hide table
| NOTE: | The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst. |
Show/hide table
Show/hide table
Show/hide table
Show/hide table
TERMINATION DATE |
| 30Sep2015 |
PROBLEM
Show/hide table
| The existing Drive Shaft (Rear) Bolts can loosen and fail on certain R1600G Load Haul Dump Machines. If the existing Drive Shaft (Rear) Bolts fails it can cause damage to Transmission Case. |
AFFECTED PRODUCT
Show/hide table
| Model | Identification Number |
| R1600G | 9YZ00401-01047 |
PARTS NEEDED
Show/hide table
Qty |
Part Number | Description |
| 8 | 0S0484 | BOLT |
| 8 | 9V3811 | BOLT |
| In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 9% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer. | ||
ACTION REQUIRED
Show/hide table
| Refer to the Service Manual if/as necessary. See the Dissassembly and Assembly, RENR7834, "R1600G Load Haul Dump Power Train", "Drive Shaft (Rear) - Remove and Install" for the procedure to replace the bolts. |
Show/hide table
SERVICE CLAIM ALLOWANCES
Show/hide table
0-24 mo |
||||||
Show/hide table
| NOTE: This is a 1.5-hour job | ||||||
Show/hide table
PARTS DISPOSITION
Show/hide table
| Handle the parts in accordance with your Warranty Bulletin on warranty parts handling. |
Caterpillar Information System:
PRODUCT SUPPORT PROGRAM FOR UPDATING THE HYDRAULIC OIL LEVEL SWITCH TO A SENSOR ON CERTAIN 795F AC OFF HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR UPDATING THE HYDRAULIC OIL LEVEL SWITCH TO A SENSOR ON CERTAIN 795F AC OFF HIGHWAY TRUCKS
PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE 8T-4132 FAN NUT ON CERTAIN 824H WHEEL DOZERS, 825H SOIL COMPACTORS, AND 826H LANDFILL COMPACTORS PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE 8T-4132 FAN NUT ON CERTAIN 824H WHEEL DOZERS, 825H SOIL COMPACTORS, AND 826H LANDFILL COMPACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE 293-0742 FAN LINES TUBE ON CERTAIN 793F, 793F XQ, AND 793F CMD OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPLACING THE 293-0742 FAN LINES TUBE ON CERTAIN 793F, 793F XQ, AND 793F CMD OFF-HIGHWAY TRUCKS
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE DIFFERENTIAL DRIVE BOLTS ON CERTAIN AP300 ASPHALT PAVERS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE DIFFERENTIAL DRIVE BOLTS ON CERTAIN AP300 ASPHALT PAVERS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE EXHAUST SHIELD ON CERTAIN R1700G LOAD HAUL DUMP MACHINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE EXHAUST SHIELD ON CERTAIN R1700G LOAD HAUL DUMP MACHINES
PRODUCT SUPPORT PROGRAM FOR UPDATING THE HYDRAULIC OIL LEVEL SWITCH TO A SENSOR ON CERTAIN 793F AND 793F AC OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR UPDATING THE HYDRAULIC OIL LEVEL SWITCH TO A SENSOR ON CERTAIN 793F AND 793F AC OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE 420-6889 WIRING HARNESS AT THE WATER IN FUEL 363-5084 SENSOR ON CERTAIN 559C, 2384C, 579C, AND 2484C KNUCKELBOOM LOADERS PRODUCT SUPPORT PROGRAM FOR REWORKING THE 420-6889 WIRING HARNESS AT THE WATER IN FUEL 363-5084 SENSOR ON CERTAIN 559C, 2384C, 579C, AND 2484C KNUCKELBOOM LOADERS
PRODUCT IMPROVEMENT PROGRAM FOR FLASHING NEW LASER DETECTION AND RANGING (LADAR) FIRMWARE ON CERTAIN MINEGEM MACHINE CONTROL AND GUIDANCE PRODUCTS PRODUCT IMPROVEMENT PROGRAM FOR FLASHING NEW LASER DETECTION AND RANGING (LADAR) FIRMWARE ON CERTAIN MINEGEM MACHINE CONTROL AND GUIDANCE PRODUCTS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE FUEL TANK ON CERTAIN 789D AND 789D XQ OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REWORKING THE FUEL TANK ON CERTAIN 789D AND 789D XQ OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE ENGINE OIL FILTERS ON CERTAIN 793B OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPLACING THE ENGINE OIL FILTERS ON CERTAIN 793B OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE FINAL DRIVE MID AXLE BEARING, HOUSING, AND AXLE SHAFT ON CERTAIN 795F AC OFF HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REWORKING THE FINAL DRIVE MID AXLE BEARING, HOUSING, AND AXLE SHAFT ON CERTAIN 795F AC OFF HIGHWAY TRUCKS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING THE ROTOR COOLANT LEVEL ON CERTAIN PM200 COLD PLANERS PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING THE ROTOR COOLANT LEVEL ON CERTAIN PM200 COLD PLANERS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE TILT CYLINDER ASSEMBLY ON CERTAIN R1700G LOAD HAUL DUMP MACHINES WITH CAP WELD FRACTURES OR TUBE BALLOONING PRODUCT SUPPORT PROGRAM FOR REWORKING THE TILT CYLINDER ASSEMBLY ON CERTAIN R1700G LOAD HAUL DUMP MACHINES WITH CAP WELD FRACTURES OR TUBE BALLOONING
PRODUCT SUPPORT PROGRAM FOR INSPECTION, AND POSSIBLE REPLACEMENT, OF THE HYDRAULIC BRAKE COOLING SUPPLY TUBES ON CERTAIN 793D AND 793F OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR INSPECTION, AND POSSIBLE REPLACEMENT, OF THE HYDRAULIC BRAKE COOLING SUPPLY TUBES ON CERTAIN 793D AND 793F OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE 0549012 CARTRIDGE ASSEMBLY FOR THE SERVICE BRAKE VALVE ON CERTAIN 785C, 789C, AND 789D OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPLACING THE 0549012 CARTRIDGE ASSEMBLY FOR THE SERVICE BRAKE VALVE ON CERTAIN 785C, 789C, AND 789D OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REPAIRING THE REAR AXLE HOUSING ON CERTAIN 785C OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPAIRING THE REAR AXLE HOUSING ON CERTAIN 785C OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR INSTALLING A NEW EQUALIZER BAR END PIN RETAINER CAP ON CERTAIN 583T AND PL83 PIPELAYERS PRODUCT SUPPORT PROGRAM FOR INSTALLING A NEW EQUALIZER BAR END PIN RETAINER CAP ON CERTAIN 583T AND PL83 PIPELAYERS
PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE HYDRAULIC FILL PUMP WIRING CONNECTION AT THE BREAKER ON CERTAIN 559C, 579C, 2384C, AND 2484C KNUCKLEBOOM LOADERS PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE HYDRAULIC FILL PUMP WIRING CONNECTION AT THE BREAKER ON CERTAIN 559C, 579C, 2384C, AND 2484C KNUCKLEBOOM LOADERS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE 107-4376 HYDRAULIC TANK BOSS ON CERTAIN 559C, 2384C, AND 579C KNUCKLEBOOM LOADERS PRODUCT SUPPORT PROGRAM FOR REWORKING THE 107-4376 HYDRAULIC TANK BOSS ON CERTAIN 559C, 2384C, AND 579C KNUCKLEBOOM LOADERS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE PRODUCT LINK PL321 ON CERTAIN CATERPILLAR PRODUCTS PRODUCT SUPPORT PROGRAM FOR REPLACING THE PRODUCT LINK PL321 ON CERTAIN CATERPILLAR PRODUCTS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE TORQUE CONVERTER GUARD ON CERTAIN 797F OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPLACING THE TORQUE CONVERTER GUARD ON CERTAIN 797F OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE 258-2920 LIFT CYLINDER PINS AND 308-6542 SPACER ON CERTAIN 272D AND 272D XHP SKID STEER LOADERS AND 299D AND 299D XHP COMPACT TRACK LOADERS PRODUCT SUPPORT PROGRAM FOR REPLACING THE 258-2920 LIFT CYLINDER PINS AND 308-6542 SPACER ON CERTAIN 272D AND 272D XHP SKID STEER LOADERS AND 299D AND 299D XHP COMPACT TRACK LOADERS
PRODUCT SUPPORT PROGRAM FOR REPLACING EXHAUST BELLOWS ON CERTAIN 793F AND 795F OFF-HIGHWAY TRUCKS PRODUCT SUPPORT PROGRAM FOR REPLACING EXHAUST BELLOWS ON CERTAIN 793F AND 795F OFF-HIGHWAY TRUCKS
PRODUCT SUPPORT PROGRAM FOR ADDITIONAL ASSISTANCE WITH REWORKS ON CERTAIN 16M MOTOR GRADERS PRODUCT SUPPORT PROGRAM FOR ADDITIONAL ASSISTANCE WITH REWORKS ON CERTAIN 16M MOTOR GRADERS