Service Parts Available For Hydraulic Controller {5466}
Usage:
TH62 (4TM, 3LN),
TH63 (5WM, 3NN),
TH82 (3JN, 3KN),
TH83 (3RN) Telehandlers
- SUPPLEMENT: JUNE 15, 1998
Service Magazine SEPD0319, Article 26, Page 24, September 2, 1996; "Service Parts Available For Hydraulic Controller".
This article contains incorrect information. For the correct information, please see Service Magazine SEPD0421, Article 14, Page 15 titled "Correction To Service Parts Available For Hydraulic Controller".
--------------- END SUPPLEMENT ---------------
Service parts are available for 8I-3632 Hydraulic Controller. The service part number is 133-0956 Controller Group. The components of this group are shown in Illustration 1 and in Chart 1 below.
Illustration 1.
Caterpillar Information System:
1996/09/02 Attachment Coupler "Z" Bar Linkage Improved {5133}
1996/09/02 Seal Added To Oscillation Bearing Joint {6604,3278}
1996/09/02 Oscillation Bearing Cover Improved {7057,7050,4302}
1996/09/02 Asphalt Paver Truck Hitch/Push Roller Pivot Pin Assembly Weldment Failures {7122}
1996/09/02 New Accumulator For Ride Control Has Higher Burst Pressure Rate {5177}
1996/09/02 New Bevel Pinion Tapered Bearing Setting Procedure Used In The Differential And Bevel Gear Group {3257,3258,3280,7551}
1996/09/02 New Longer Bolts And Hard Washers Prevent Rear Wheel Bearing Retainer Bolts From Loosening {4201,4208,4234}
1996/09/02 Insufficient Monitoring Of ENGINE COOLANT FLOW By Vital Information System (VIMS) {1395,1920,7852}
1996/09/02 Changes To Turbocharger Support Group And Lifting Group Allow Easier Engine Removal And Installation {1052,1122}
1996/09/02 New Stem Provides Improved Hydraulic Stability When Tilting Loader Bucket {5123}
1996/09/02 New Swing Cylinder Groups Use Wider Trunnion For Better Load Distribution {5105,7562}
1996/09/02 New Swing Cylinder Groups Provide Higher Load Capability {5105,7562}
1996/09/02 New Start Switch With Improved Moisture Resistance {1416}
1996/09/02 Improved Starter Solenoid Assemblies Available {1467,1518}
1996/09/09 Machine Electronic Control Module Software Improvements{0700,0785,1901}
1996/09/09 Engine Block Provides Improved Grounding To Frame Grounding Cable{1201,1405,1406,7423}
1996/09/09 New Parts Available To Eliminate Wear Between The Oil Cooler Bonnet And The Elbow{1378,1380}
1996/09/09 New Plate Used For Tightening Fan Belts Which Use Alternator Assembly Belt Tighteners{1400,1358,1357}
1996/09/09 A New Seal For Brake Piston Plug In Front Brake Groups (Caliper Disc) Has Been Released For Service Repair{4251,7555}
1996/09/09 Do Not Wash Hot Fuel Injection Pump With Cold Water{1251}
1996/09/09 A Chamfer Has Been Added To Some Engine Cylinder Head Bolt Holes To Help Reduce Stress Concentrations And Prevent Cracks{1101}
1996/09/16 New Transmission Bearing Improves Surface Fatigue Life {3030}
1996/09/16 Brake Components Resized To Improve Heat Capacity {4250,4251}
1996/09/16 Rotated Extension Stick Cylinder Protects Cylinder Port {5057}