Usage:
start by:
a) remove cylinder head assembly
1. Install seven 3/8"-16 NC forcing screws (1) in the spacer plate. Tighten the forcing screws evenly.
2. Remove spacer plate (2) from the cylinder block.
NOTE: Do not cause damage to the dowels.
Install Spacer Plate
1. Thoroughly clean the spacer plate and cylinder block surface.
2. Install a new gasket (2) between the spacer plate and cylinder block. Put spacer plate (1) in position on the cylinder block.
NOTE: Later model engines have two O-ring seals on top and bottom of the spacer plate.
NOTICE |
---|
Both surfaces of the spacer plate, top of cylinder block and both sides of the spacer plate gasket must be clean and dry. Gasket adhesives or other substances must not be used on these surfaces. |
3. Check cylinder liner projection. See INSTALL CYLINDER LINERS.
end by:
a) install cylinder head assembly