New Service Centers For 6V3100 Engine Timing Indicator Group{0651}
Usage:
Snap-on Tools Corporation has opened a new Mid-west service center and their existing Canadian service center has been equipped to service the 6V3100 Engine Timing Indicator Group. The addresses for these service centers are:
Midwest Service Center address:
Midwest Service Center
2300 Commerce
New Berlin, Wisconsin 53151
U.S.A.
Telephone: (414) 785-9996
Canadian service center mailing address:
Repair Center
P. O. Box 8271
Concord, Ontario, Canada
L4K-1E4
Telephone: (416) 669-9501
Canadian service center shipping address:
Repair Center
Attention: Manager
8271 Keele Street
Vaughn Township
Concord, Ontario, Canada
Caterpillar Information System:
1983/10/10 New Connecting Rod And Main Bearings Used{1203,1219,1226,1227,1230}
1983/10/10 S.O.S Program Synopsis{1318,5068,3179,0652}
1983/10/03 Use 6V6070 Tool Group And New Adjustment Procedure For New Scroll Fuel System{0654,1264,1278}
1983/09/26 New Seals Used In Tandem Drive Group{4064,4062,4071}
1983/09/26 Clearance Between Boom And Upper Frame{6501}
1983/09/26 New Drawbar And Yoke Assemblies Have Stronger Cross Bar To Prevent Damage{6153}
1983/09/26 Product Identification Number To Replace Serial Number On Earthmoving Equipment{7557}
1983/09/26 New Cover Assemblies For Transmission Hydraulic Controls Permit Better Access to Pressure Fittings{3150}
1983/09/26 Service Information For Woodward Governors{0374,1264}
1983/09/26 Oil Shield And Rotocoil Must Be Installed Together For Acceptable Oil Control{1109}
1983/09/12 Parts Service Information For Pistons, Connecting Rods, Piston Pins And Rings{1214,1225,1215,1218}
1983/09/12 New Grease Lines Groups Make Lubrication Of Front And Rear Suspension Cylinders Easier{7201,7113}
1983/10/10 New Water Pump Oil Seal Prevents Leaks{1361}
1983/10/10 Cab Head Lamps Mounted In New Location For Better Protection{7309}
1983/10/17 Broken Edge Filter Or Plugged Cylinder Head Adapter Can Cause Rough Engine Operation Or Low Power{1252}
1983/10/17 Fan Drive Conversion Group Available To Change Fans From Gear Driven To Belt Driven{1359,1356}
1983/10/17 Installation Of Vent Assembly Helps Prevent Oil Leakage In The Wheel Leaning Mechanism{5224}
1983/10/17 New Rod And Seal Used To Prevent Oil Leakage Into The Transmission Neutralizer Group{3181}
1983/10/17 Instrument Panel Changed To Give Better Fit For Gauges{7451}
1983/10/17 Modification Of Control Panel Gives Different Power Source For Overcrank Timer To Prevent Starter Motor Failures{7450}
1983/10/17 Stronger Spider Assemblies Used In Fan Groups{1356}
1983/10/17 Changes To Torque Converter Inlet Relief Valve Increase Service Life{3167}
1983/10/17 If The Cab Door Is Difficult To Open, Check Nylon Washer For Damage{7308}
1983/10/17 Use Shims At Both Ends Of Housing Assembly To Prevent Oil Leakage From Power Control Group{5201}