Improved 1U-7430 Front Crankshaft Seal Installer Available{1160}
Usage:
3114 (5EF, 1ZG),
3116 (2WG, 4PG) Industrial;
3114 (6AF, 5JG),
3116 (2SG, 1NJ) Generator Set;
3116 (4KG, 1SK) Marine Engines
An improved 1U-7430 Seal Installer is available to install the front crankshaft seal in these engines. The overall length of the improved installer has been increased by 5.0 mm (.20 in) to 35.0 mm (1.38 in). Because the improved installer is longer, it does not require the additional 5U-1118 Washers used with damper pulley mounting bolts to install the front crankshaft seal. When using the improved seal installer, tighten the damper pulley mounting bolts until the seal installer bottoms out.
Caterpillar Information System:
1995/07/01 New Repair Seal Kit Available For 7E-5038 Pilot Operated Valve In Oil Lines Groups{1307}
1995/07/01 New Bracket Installed On New Oil Pump Group Helps Reduce Vibration In Water Lines Group{1380}
1995/07/01 New Auxiliary Pump Group Used{1371}
1995/07/01 New Gasket Added To Housing Control Group To Prevent Moisture Penetration{1287}
1995/07/01 New Liner Seat Inserts Allow Cylinder Blocks With Deeper Liner Seat Cracks To Be Salvaged{1201,1217}
1995/07/01 Two New Attachment Start Switch Groups Provide Improved Resistance To Vibration Damage{1416}
1995/07/01 Caterpillar Long Life Coolant/Antifreeze Identification{1395}
1995/06/01 Caterpillar Recommends Installing Temporary Strainer To Remove Possible Debris in Cooling System During New Engine Start-Up{1350}
1995/06/01 Alignment Of Front Gear Train Idler Shaft{1206}
1995/06/01 Main Bearing Cap Installation Procedure{1203}
1995/06/01 New Cylinder Head And Cylinder Liner Gasket Kits Available{1124,1100,1216}
1995/06/01 New Combustion Gaskets Provide Improved Sealing{1124}
1995/08/01 Piston Usage Chart For Two Piece Pistons{1214}
1995/08/01 New "High Efficiency" Fuel Filters Help Prevent Worn Injectors{1261}
1995/08/01 Improved Cylinder Head Group Components And Valve Mechanism Group Components Provide Increased Service Life{1100,1102,1103,1104,1105}
1995/08/01 Valve Lash Adjustment Intervals{1105}
1995/08/01 Wear Sleeve Removal Tooling May "Mark" The Crankshaft{1202,1161}
1995/08/01 New Oil Seal And Seal Collar Used In Auxiliary Sea Water Pump Groups{1371}
1995/08/01 Check For Correct Location Of Trolling Mode Input Wire{1408}
1995/08/01 New Piston Crown Assembly Used In Piston And Rod Group{1214}
1995/08/01 New Rain Shields And Automatic Draining Precleaner Cup Assembly Available{1051}
1995/08/01 New Air Cleaner And Silencer Has Increased Noise Attenuation{1051,1054}
1995/08/01 New Turbocharger Bearing Clearance Specifications{1052,1053}
1995/08/01 Turbocharger Cartridge Groups Available For Parts Service{1053,1052}