1985/08/01 Caterpillar


Eliminating Interference Between Governor Housing And Tachometer Drive

Usage:


3406B Industrial, Marine And Generator Set Engines

There have been reports of interference between the 2W1842 PSG Governor Group and both the 1W8235 and 4W1101 Tachometer Drive Groups. This interference has been eliminated but difficulty may be encountered when replacing a PSG governor on an older engine. Refer to the illustration.


Location of interference.

This interference can be eliminated by grinding off not more than 2.54 mm (.10") of material from the governor housing at the point of interference. If there is still interference, grind material from the tachometer drive group.

NOTE: Remove only enough material to obtain clearance.

Caterpillar Information System:

1985/08/01 Thread Sealant Must Be Used On Air Compressor Mounting Bracket Bolts
1985/08/01 New Service Tools Available
1985/08/01 Head Gasket Replacement Procedure
1985/08/01 Thread Lock Now Used On Timing Advance Bolts
1985/08/01 Remanufactured Cylinder Head Group For NA Engines Must Not Be Installed On T Engines
1985/08/01 Engine Rotation Can Be Changed On 3500 Series Engines
1985/08/01 Correct Location And Rotation Of Front Timing Gears
1985/08/01 Tachometer Drive Is Now An Attachment
1985/07/01 How To Reduce Costs And Increase Marine Engine Life
1985/07/01 Oil Pump Flow Increased
1985/07/01 Battery Disconnect Switch Stops Battery Drain
1985/07/01 New Part Numbers Designate Crankshaft Use
1985/08/01 Rough Handling Can Move Droop Lever Out Of Position
1985/08/01 Extra Injection Nozzle Clamp Helps Prevent Injection Nozzle Damage
1985/08/01 Problems Caused By Electric Governors That Are Not Supplied By Caterpillar
1985/08/01 Change To Astern Drive Shaft Reduces Horsepower Loss And Improves Ahead Clutch Cooling
1985/08/01 Hardened Washers Used In Engine Oil Lines; Locks Removed From Oil Pump
1985/08/01 New, Corrosion Resistant Water Pump Shaft Available
1985/08/01 New Type Of Paint Used On Some Caterpillar Products; Do Not Weld On Painted Surfaces
1985/08/01 Use Care When Handling Water Seals For Cylinder Head Spacer Plates
1985/08/01 Stronger Push Rod Used
1985/08/01 Location Of 6V5135 Setscrews In Fuel Pump Group
1985/08/01 Valve Mechanism Groups Use New Lifter Assemblies
1985/08/01 Special Instruction Available To Salvage Governor Housing
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.