Track Roller (Single Flange)
Show/hide table
Illustration 1 | g06027119 |
Show/hide table
Specifications for 497-8871 Track Roller Gp | |||
---|---|---|---|
Item | Qty | Part | Specification Description |
1 | 2 | 497-8889 Roller Bushing As | Bore after assembly is |
2 | 2 | 6S-3285 Duo-Cone Seal Gp | The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin layer of oil to the contacting surfaces of the metal seal rings. The seal rings must be assembled square. The rubber toric seal should not bulge and the rubber toric seal should not twist. Refer to Special Instruction, SEHS8364, "Assembly and Installation of Conventional Duo-Cone Seals" |
3 | 2 | 7D-9749 O-Ring Seal | Lubricate the bore lightly with the lubricant that is being sealed. |
- | - | - | End play for the track roller shaft:
Minimum is Maximum is |
Caterpillar Information System:
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Electronic Control Module
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Steering Lines
C12.9 Marine Engines Crankshaft Pulley - Remove and Install
C175-16 and C175-20 Locomotive Engines Turbocharger - Install
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Machine Electronic Control Module Mounting
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Operator Console
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Track Tension Lines
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Access Door
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Lines (Conveyor) - Motor
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Return Lines
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Hydraulic Oil Lines - Clutch
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Hydraulic Lines - Cylinder
745 and 740 GC & 740 EJECTOR Articulated Truck Systems Check Valve
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Check Valve
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Control Valve and Mounting
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Steering Control Group
C18 Generator Set Engines DEF Injector and Mounting - Remove and Install
C18 Generator Set Engines Manifold (DEF Heater) - Remove and Install
Exhaust Manifold for Certain C1.5 Marine Generator Sets {1059} Exhaust Manifold for Certain C1.5 Marine Generator Sets {1059}
C1.7 and C2.2 Industrial Engine Relay - Test - Fan Drive Relay
C12.9 Marine Engines Water Pump - Remove and Install
C12.9 Marine Engines Crankcase Breather - Remove and Install
C7.1-XQ230 Rental Generator Set Before Starting Engine
C7.1-XQ230 Rental Generator Set General Hazard Information