Gas Pressure Regulator - Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install gas pressure regulator (3), the washers, and bolts (4).
- Connect tube assembly (1) to the fitting on gas pressure regulator (3).
- Install clamps (2) on the joint. Tighten the clamp bolt to a torque of
17 ± 1 N·m (13 ± 1 lb ft)
Show/hide table
| |
| Illustration 1 | g06000409 |
End By:
- Install the gas pressure regulator solenoid.
Caterpillar Information System:
A New Coolant Elbow Assembly is Now Used on Certain C18 Marine Engines {1059} A New Coolant Elbow Assembly is Now Used on Certain C18 Marine Engines {1059}
G3508J, G3516J, and G3520J Engines Gas Pressure Regulator - Remove
3516B Generator Set with Dynamic Gas Blending Alternator Mounting
A New Fuel Valve Is Now Used for Certain G3500BPetroleum Engines and G3500H Electric Power Engines {1741, 5137} A New Fuel Valve Is Now Used for Certain G3500BPetroleum Engines and G3500H Electric Power Engines {1741, 5137}
797 Off-Highway Truck Link and Rear Cylinder (Suspension) - Check
New Software is Available for Certain C4.4 Engines {1920} New Software is Available for Certain C4.4 Engines {1920}
3500E Marine Engines Fuel Injector Mechanism
3516E Generator Set Engines Accessory Drive
3516E Generator Set Engines Flywheel Housing Cover
3516E Generator Set Engines Engine Oil Pan
G3500H 60Hz Generator Sets Product Storage
G3500H 60Hz Generator Sets Reference Information
G3508J, G3516J, and G3520J Engines Gas Pressure Regulator Solenoid - Remove and Install
3516E Generator Set Engines Fuel Injector
3516E Generator Set Engines Flywheel Housing
3516E Generator Set Engines Crankshaft
3516E Generator Set Engines Engine Oil Filter
G3500H 60Hz Generator Sets Before Starting Engine
3516E Generator Set Engines Auxiliary Water Pump
G3500H 60Hz Generator Sets Starting the Engine
G3500H 60Hz Generator Sets Engine Operation
EMCP 4.4 Supervisory Control Panel Starting and Stopping
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Generator Operation
New Crankshaft Seals Are Not Compatible with the Front Adapter on Certain 3500 Mechanical Unit Injection Machine Engines {1160, 1161} New Crankshaft Seals Are Not Compatible with the Front Adapter on Certain 3500 Mechanical Unit Injection Machine Engines {1160, 1161}