Modem - Replace
- Verify that the system is shut down and that all safety procedures are followed.
Show/hide table
Illustration 1 g03891019 (1) Power cable
(2) DB-9 connector
(3) Modem
(4) Mounting screws (only one shown) - Unplug the power cable (1) and the DB-9 (2) connector from the back of the modem (3).
- Remove the two mounting screws (4).
- Remove the modem (3).
Show/hide table
Illustration 2 g03891024 (3) Modem
(5) Eject button
(6) SIM card tray - Using an insulated object, press the yellow button (5) and release the SIM card tray.
Show/hide table
Illustration 3 g03891466 (10) SIM card - Slide the tray out and remove the SIM card from the tray.
- Install the replacement modem using the reverse procedure for removal.
- Verify that the antenna is securely fastened to the modem.
- Open the SIM card tray. Install the SIM card that was removed in Step 6.
- Slide the SIM card tray with the SIM card into the modem. Press in firmly on the tray to ensure that the tray is install completely.
- Install the modem using the two mounting brackets.
- Install two mounting screws and tighten.
- Connect the DB-9 connector and power cable to the modem.
- Turn the communication control power switch to the ON position.
- Turn on the system.
- Use the Field Service Tool to modify the system configuration as needed for the SIM provider.
- The required time to configure the ESS and establish communication with the network will require approximately 2 minutes after the new SIM card is installed. The status light on the modem will blink to indicate normal communication with the network.
Caterpillar Information System:
Energy Storage System Subscriber Identity Module (SIM) Card - Replace
Energy Storage System Enclosure Filter - Replace
Energy Storage System Enclosure Fan - Replace
Energy Storage System Cathode Fan - Replace
Energy Storage System Communication Control - Replace
Energy Storage System Cell - Replace
Energy Storage System Powering Off and On
Energy Storage System Safety Precautions
Energy Storage System Serviceable Parts and Tools
Energy Storage System Preventative Maintenance
Energy Storage System General Information
Energy Storage System Acceptance Test Procedure
Energy Storage System Harness and Cable - Replace
Energy Storage System Fault Codes Structure
Energy Storage System System Level Faults
Energy Storage System Module Level Faults
Aftertreatment Intake NOx Sensor Failing at Early Hours on Certain C13 Engines used in Claas Combines{191N} Aftertreatment Intake NOx Sensor Failing at Early Hours on Certain C13 Engines used in Claas Combines{191N}
Energy Storage System Cell Level Faults
120 and 120 AWD Motor Grader Mirror - If Equipped
Machine Security System (MSS3i) Integrated General Information
120 and 120 AWD Motor Grader Battery Disconnect Switch
Machine Security System (MSS3i) Integrated System Overview
Machine Security System (MSS3i) Integrated Operation of Status Indicator
3512C Generator Set Engine Engine Oil Filter Housing - Disassemble