DEF Pump Power Supply - Test
使用此步骤对柴油机排气处理液 (DEF) 泵电源故障进行故障诊断与排除。 如果以下诊断代码为激活状态或易于重复,也采用本步骤。
Show/hide table
J1939 代码和描述 | 注释 |
---|---|
7417-2
后处理 #1 DEF 控制器:不稳定、间歇或不正确 |
发动机运转时,120 VAC 断路器断开。 |
Show/hide table
故障诊断与排除测试步骤 | 数值 | 结果 |
---|---|---|
1. 检查代码 A. 连接 Cat® 电子技师 (ET) 与维修工具接头。 B。 确定是否有代码激活或记录。 |
代码 |
结果:代码激活或被记录。 转至测试步骤 2。 |
2. 检查喷射机柜上的 AC 断路器 A. 拆下喷射机柜面板,以检修 AC 柴油机排气处理液 (DEF) 泵断路器。 B。 确认喷射机柜前面的 AC 断路器处于接通位置。 |
断路器 |
结果:AC DEF 泵断路器处于接通位置。 转至测试步骤 3。 结果:AC DEF 泵断路器没有处于接通位置。 修理:将 AC DEF 泵断路器置于接通位置。 如果故障未得到排除,则转至测试步骤 3。 |
3. 运转发动机。 A. 将配电箱上的 DC 断路器转至关闭位置至少 1 分钟。 B。 将配电箱上的 DC 断路器转至接通位置。 C. 起动发动机。 D. 运转发动机,直到达到正常工作温度。 E. 连接 Cat ET。 F. 使用 Cat ET 监控以下各项: - 代码 |
代码 |
结果:代码未激活。 返回工作。 |
如果以上步骤未解决问题,请联系当地 Cat 代理商的技术通信员(TC)。 如需进一步的帮助,您的 TC 可以通过代理商解决方案网络(DSN)与您交谈。
Caterpillar Information System:
XQC1200 Power Module Coolant (ELC) - Change
XQC1200 Power Module Setup
Installation of Exhaust Shield Assemblies On Certain G3520C Engines {1059} Installation of Exhaust Shield Assemblies On Certain G3520C Engines {1059}
Procedure to Properly Tighten the Nuts on the Solenoid Studs on Electronic Unit Injectors (EUI){1290, 1408, 1900} Procedure to Properly Tighten the Nuts on the Solenoid Studs on Electronic Unit Injectors (EUI){1290, 1408, 1900}
C280 Marine Engines NOx Sensor - Test
3512E Tier 4 Final Engines for Land Electric Drilling NRS Exhaust Gas Temperature Is High
C13 Industrial Engine Water in Fuel - Test
C13 Industrial Engine Variable Valve Actuator Response - Test
C13 Industrial Engine Variable Valve Actuator - Test
C175-16 Locomotive Engine NOx Sensor Supply - Test
C13 Industrial Engine Switch Circuits - Test
C13 Industrial Engine Speed/Timing - Test
2014/10/31 New Recommendations for Starters and Batteries Used on 3516 Engines Operating in China {1401, 1453}
2014/11/26 A New Valve Cover Base Is Used on Certain C15 and C18 Commercial Engines {1120}
XQC1200 Power Module Coolant (DEAC) - Change
XGC1900 Generator Sets Circuit Breakers - Reset
C280 Marine Engines DEF Pump Motor - Test
C27 and C32 Engine for MD6250 and MD6310 Drill Timing - Calibrate
2014/12/05 A New Tube Is Now Used on Certain 3516 Engines {1319}
C7.1-XQ200 Rental Generator Set Maintenance Interval Schedule - Prime
Speed Instability Issues on 3512Well Service Engines Equipped with Cat® Transmission and Dynamic Gas Blending Kit {7620} Speed Instability Issues on 3512Well Service Engines Equipped with Cat® Transmission and Dynamic Gas Blending Kit {7620}
C7.1-XQ200 Rental Generator Set Maintenance Interval Schedule - Standby
C280-08 Tier 4 Engine Auxiliary Water Pump - Disassemble
C280-08 Tier 4 Engine Auxiliary Water Pump - Assemble