Inlet Manifold Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Isolate the electric power generation set. Refer to Operation and Maintenance Manual, "Generator Isolating for Maintenance" for the correct procedure.
Show/hide table
Illustration 1 g03802078 - Disconnect harness assembly (1) and remove inlet manifold pressure sensor (2).
- Remove the O-ring seal from the inlet manifold pressure sensor.
- Install inlet manifold pressure sensor (2) in the reverse order of removal.
- Tighten inlet manifold pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten inlet manifold pressure sensor (2) to a torque of
Caterpillar Information System:
PM820, PM822, and PM825 Cold Planer Moldboard Cutting Edge - Inspect/Adjust/Replace
PM820, PM822, and PM825 Cold Planer Legs (Struts) - Lubricate
460-9068 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-9068 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
PM620 and PM622 Cold Planer Hydraulic System Oil Sample - Obtain
PM620 and PM622 Cold Planer Hydraulic System Oil Level - Check
PM820, PM822, and PM825 Cold Planer Hydraulic Foldable Canopy Cylinder Ends - Lubricate
PM820, PM822, and PM825 Cold Planer Fuel Tank Water and Sediment - Drain
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Maintenance Interval Schedule
460-8974 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-8974 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
PM620 and PM622 Cold Planer Engine Oil Level - Check
C15 and C18 Tier 4 Final Engines Diesel Exhaust Fluid Quality - Test
C8.7 Marine Engine Decommissioning and Disposal
XQC1200 and XQC1600 Power Modules Inlet Manifold Temperature Sensor - Remove and Install
C8.7 Marine Engine Crankshaft Vibration Damper - Inspect
XQC1200 and XQC1600 Power Modules Temperature Sensor (Exhaust) - Remove and Install
PM820, PM822, and PM825 Cold Planer Pump Drive Oil Level - Check
PM820, PM822, and PM825 Cold Planer Pump Drive Oil Sample - Obtain
PM820, PM822, and PM825 Cold Planer Rotor Bearing Oil - Change
PM820, PM822, and PM825 Cold Planer Rotor Bearing Oil Level - Check
XQC1200 and XQC1600 Power Modules Turbocharger Inlet Pressure Sensor - Remove and Install
460-9016 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-9016 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
PM820, PM822, and PM825 Cold Planer Rotor Service Door Cylinder Pins - Lubricate
PM820, PM822, and PM825 Cold Planer Rotor Service Door Pivot Pins - Lubricate
XQC1200 and XQC1600 Power Modules Turbocharger Inlet Temperature Sensor - Remove and Install