Water Temperature Regulator Housing - Remove and Install
Removal Procedure
- Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
- Remove bolts (1) and disconnect elbow (2) .
Show/hide table
Illustration 1 | g03641000 |
- Remove bolts (3) remove water temperature regulator housing (4) .
- Remove O-ring seals (6) and water temperature regulators (7) from water temperature regulator housing (5) .
Show/hide table
Illustration 2 | g01223744 |
- If necessary, remove the lip seals.
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 221-8647     | Seal Installer Gp     | 1     |
- If necessary, use Tooling (A) to install the lip seals.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install water temperature regulators (7) and O-ring seals (6) in water temperature regulator housing (5) .
Show/hide table
Illustration 3 | g01223744 |
- Position water temperature regulator housing (4) on the engine. Install bolts (3) and bolts (1) .
Show/hide table
Illustration 4 | g03641000 |
- Connect elbow (2) .
- Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Caterpillar Information System:
2014/03/07 A New Jacket Water Elbow and Tube Assembly Are Used on Certain 3516C HD Marine Tier 3 Engines {1380}
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install - Right Side and Left Side
374F Excavator Air Cleaner Dust Valve - Clean/Inspect
390F Excavator Engine Enclosure - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C4.4 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
390F Excavator C18 Engine Supplement Hood - Remove and Install - Clean Emissions Module
C4.4 Marine Generator Set Sea Water Pump Pressure Is Low
390F Excavator Machine Systems Control Valve (Boom Lowering)
UPS 750 Uninterruptible Power Supply System Operational Modes
G3600 A4 Engines Refill Capacities
374F Excavator Lifting and Tying Down the Machine
C27 and C32 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
390F Excavator C18 Engine Supplement Engine Rear Mount - Remove and Install
C175-16 Petroleum Generator Set Engines Control Panel
390F Excavator C18 Engine Supplement Engine - Remove and Install
390F Excavator Fan Guard - Remove and Install - Rear
XQC1600 Power Module Fuel System Primary Filter/Water Separator - Drain
G3306B Generator Sets Model View Illustrations
G3306B Generator Sets Product Description
G3306B Generator Sets Declaration of Conformity
G3306B Generator Sets Generator Lead Connections