Engine Enclosure - Remove and Install
拆卸步骤
开始:
- 拆下清洁排放模块发动机罩。
- 将适当的起吊设备安装到发动机罩组件 (2) 上。 发动机罩组件 (2) 的重量约为 51 kg (112 lb)。 拆下螺栓 (1) 和发动机罩组件 (2) 。
Show/hide table
 | |
| 图 1 | g03640019 |
- 拆下薄片组件 (3) 、 (4) 和 (5) 。
Show/hide table
 | |
| 图 2 | g03640458 |
- 拆下螺栓 (8) 和薄片 (9) 。 拆下螺栓 (6) 和薄片 (7) 。
Show/hide table
 | |
| 图 3 | g03640696 |
- 松开卡箍 (10) 。 拆下螺栓 (11) 。 由两名人员拆下支架 (12) 。 支架 (12) 的重量约为 44 kg (97 lb)。
Show/hide table
 | |
| 图 4 | g03640487 |
Show/hide table
 | |
| 图 5 | g03640618 |
安装步骤
- 按与拆卸相反的顺序安装发动机外壳。
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C4.4 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
390F Excavator C18 Engine Supplement Hood - Remove and Install - Clean Emissions Module
C4.4 Marine Generator Set Sea Water Pump Pressure Is Low
390F Excavator Machine Systems Control Valve (Boom Lowering)
UPS 750 Uninterruptible Power Supply System Operational Modes
G3600 A4 Engines Refill Capacities
374F Excavator Lifting and Tying Down the Machine
390F MHPU Mobile Hydraulic Power Unit Machine System Relief Valve (Main)
390F MHPU Mobile Hydraulic Power Unit Machine System Main Hydraulic Pump
G3600 A4 Engines Safety Messages
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
374F Excavator Air Cleaner Dust Valve - Clean/Inspect
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install - Right Side and Left Side
2014/03/07 A New Jacket Water Elbow and Tube Assembly Are Used on Certain 3516C HD Marine Tier 3 Engines {1380}
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
390F Excavator C18 Engine Supplement Engine Rear Mount - Remove and Install
C175-16 Petroleum Generator Set Engines Control Panel
390F Excavator C18 Engine Supplement Engine - Remove and Install
390F Excavator Fan Guard - Remove and Install - Rear
XQC1600 Power Module Fuel System Primary Filter/Water Separator - Drain