Engine Rating Definitions
必须降低额定功率以便适应海拔高度的变化。 降低额定功率必须依据从发动机测试规格中获得的减额数据来进行。
所有确定的额定功率都有 ±3% 的制造公差。
运用以下指导原则以便确定适用的发动机额定功率。
Show/hide table
注意 |
---|
在超出额定功率输出的工况下运行将使发动机大修前的使用寿命缩短。 |
海上钻井 - 电力 - 最大连续额定功率(MCR)遵循国际船级社协会(IACS)主发动机和辅助发动机参考条件。 十二(12)小时的作业内允许过载 10% 运行一(1)小时。
陆上油气生产 - 电力 - 主用额定功率允许 10% 过载(船级社(MCS)认证)。 输出可供在负载变化、时间不受限制的情况下使用。 主用功率符合 ISO 8528。
海上应急 - 电力 - 主用额定功率允许 10% 过载(船级社(MCS)认证)。 输出可供在负载变化、时间不受限制的情况下使用。 主用功率符合 ISO 8528。
Caterpillar Information System:
CX31 and CX31 HT On-Highway Transmissions Maintenance Interval Schedule
390F Excavator C18 Engine Supplement Water Temperature Regulator - Remove and Install
390F Excavator Air Cleaner - Remove and Install
UPS 750 Uninterruptible Power Supply Specifications
390F Excavator Engine Electronic Control - Remove and Install
390F Excavator C18 Engine Supplement Engine Oil Cooler - Remove and Install
390F Excavator Engine Oil Filter Base - Assemble
390F Excavator Engine Oil Filter Base - Disassemble
C3.4B Engines Solenoid Valve - Test
390F Excavator Engine Oil Filter Base - Remove and Install
2014/03/10 Improved Torque Converter Housings Are Now Used on Certain On-Highway Transmissions, Petroleum Transmissions, and Petroleum Power Train Packages {3105}
C4.4 Engines for Caterpillar Built Machines Gear Group (Front) - Time
CX31 On-Highway Transmission Maintenance Interval Schedule
CX35 On-Highway Transmission Maintenance Interval Schedule
C4.4 Marine Generator Set Sensors and Electrical Connectors
C3.4B Engines Speed/Timing - Test
Autonomous Calibration Procedure for Off-Highway Trucks Equipped with the Command Package {7008, 7605, 79AU} Autonomous Calibration Procedure for Off-Highway Trucks Equipped with the Command Package {7008, 7605, 79AU}
390F Excavator C18 Engine Supplement Turbocharger - Remove and Install
3500 Generator Sets with Dynamic Gas Blending Gas Filter Condensation - Drain
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Manual Hydraulic Valve - Health Check
390F Excavator Water Pump - Remove and Install
374F Excavator Alternate Exit
2014/05/16 New Software Is Used on Certain Tier 4 Interim Industrial Engines {1901, 1902, 1920}
390F Excavator Engine Front Mount - Remove and Install