Valve Lifter - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01212600 |
Show/hide table
Illustration 2 | g01212691 |
- Install new guide springs (3) and (4) on valve lifters (6) and unit injector lifter (8) if the original guide spring was removed.
Note: The guide springs must not be used again if the guide spring was removed from the valve lifter. If the guide spring was removed, install a new guide spring always.
- Install inserts (2) while the end that is recessed is facing outward. Install new O-ring seals (1) in order to hold the inserts in place.
- Immerse valve lifters (6) and unit injector lifter (8) in clean engine oil.
Note: Compress guide springs (3) so that valve lifters (6) can be installed in guide (5).
- Install valve lifters (6) in the original positions. Install the valve lifters so that the guide spring will be in the correct position.
- Install unit injector lifter (8).
- Install the valve lifters and the unit injector lifter to Dimension (X). Dimension (X) is
118.0 ± 2.0 mm (4.60 ± 0.10 inch) .
End By:
- Install the valve lifter.
Caterpillar Information System:
C280-08 Tier 4 Engine Valve Lifter - Disassemble
C280-08 Tier 4 Engine Valve Lifter - Remove and Install
C280-08 Tier 4 Engine Rocker Arm - Assemble
C280-08 Tier 4 Engine Rocker Arm - Disassemble
C4.4 Marine Generator Set Sensors and Electrical Components
390F Excavator Machine Systems Recoil Spring - Assemble
390F Excavator Machine Systems Recoil Spring - Disassemble
G3600 A4 Engines Crankshaft Deflection (Bend)
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Housing (Rear) - Remove and Install
DRCP Connector Repair Service Instruction {1408, 7553} DRCP Connector Repair Service Instruction {1408, 7553}
C4.4 Marine Generator Set Electronic Service Tool Does Not Communicate
C4.4 Marine Generator Set ECM Will Not Accept Factory Passwords
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Fuel Injector - Remove and Install
C280-08 Tier 4 Engine Cylinder Head - Remove
C280-08 Tier 4 Engine Cylinder Head - Install
C280-08 Tier 4 Engine Cylinder Head - Disassemble
C280-08 Tier 4 Engine Cylinder Head - Assemble
C280-08 Tier 4 Engine Piston Cooling Jets - Remove and Install
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Default Value of Work Tool Parameters
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Relief Valve (Line) - Test and Adjust
C280-08 Tier 4 Engine Cylinder Liner - Remove
C280-08 Tier 4 Engine Cylinder Liner - Install
C280-08 Tier 4 Engine Camshaft - Remove
C280-08 Tier 4 Engine Camshaft - Install