Valve Lifter - Remove and Install
Start By:
- Remove the rocker shaft and pushrod.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the bolts and cover (1) from the side of the cylinder head. Remove the O-ring seals (not shown).
Show/hide table
Illustration 2 g01298655 - Remove oil supply tube assembly (2).
- Remove bolts (4) and remove valve lifter group (3).
Show/hide table
| |
| Illustration 1 | g03744357 |
- Install valve lifter group (3) in the reverse order of removal.
Caterpillar Information System:
C280-08 Tier 4 Engine Rocker Arm - Assemble
C280-08 Tier 4 Engine Rocker Arm - Disassemble
C4.4 Marine Generator Set Sensors and Electrical Components
390F Excavator Machine Systems Recoil Spring - Assemble
390F Excavator Machine Systems Recoil Spring - Disassemble
G3600 A4 Engines Crankshaft Deflection (Bend)
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Housing (Rear) - Remove and Install
DRCP Connector Repair Service Instruction {1408, 7553} DRCP Connector Repair Service Instruction {1408, 7553}
C4.4 Marine Generator Set Electronic Service Tool Does Not Communicate
C4.4 Marine Generator Set ECM Will Not Accept Factory Passwords
C4.4 Marine Generator Set ECM Does Not Communicate with Other Modules
C4.4 Marine Generator Set Cylinder Is Noisy
C280-08 Tier 4 Engine Valve Lifter - Disassemble
C280-08 Tier 4 Engine Valve Lifter - Assemble
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Fuel Injector - Remove and Install
C280-08 Tier 4 Engine Cylinder Head - Remove
C280-08 Tier 4 Engine Cylinder Head - Install
C280-08 Tier 4 Engine Cylinder Head - Disassemble
C280-08 Tier 4 Engine Cylinder Head - Assemble
C280-08 Tier 4 Engine Piston Cooling Jets - Remove and Install
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Default Value of Work Tool Parameters
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Relief Valve (Line) - Test and Adjust
C280-08 Tier 4 Engine Cylinder Liner - Remove
C280-08 Tier 4 Engine Cylinder Liner - Install