Rocker Arm - Disassemble
Start By:
- Remove the rocker shaft and pushrod.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01297832 |
- Remove bolts (2) and the washers from rocker arm shaft (1).
- Put identification marks on all of the components for assembly purposes.
- Remove the bolts and plate (4) from one end of rocker arm shaft (1).
- Remove rocker arms (3) from rocker arm shaft (1).
Show/hide table
Illustration 2 g01297835 Note: The O-ring seals hold buttons (5) in place on the rocker arms.
- Remove buttons (5). Remove the O-ring seal from buttons (5).
Caterpillar Information System:
C4.4 Marine Generator Set Sensors and Electrical Components
390F Excavator Machine Systems Recoil Spring - Assemble
390F Excavator Machine Systems Recoil Spring - Disassemble
G3600 A4 Engines Crankshaft Deflection (Bend)
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Housing (Rear) - Remove and Install
DRCP Connector Repair Service Instruction {1408, 7553} DRCP Connector Repair Service Instruction {1408, 7553}
C4.4 Marine Generator Set Electronic Service Tool Does Not Communicate
C4.4 Marine Generator Set ECM Will Not Accept Factory Passwords
C4.4 Marine Generator Set ECM Does Not Communicate with Other Modules
C4.4 Marine Generator Set Cylinder Is Noisy
140 Motor Graders Air Lines
140 Motor Graders Air Cleaner
C280-08 Tier 4 Engine Rocker Arm - Assemble
C280-08 Tier 4 Engine Valve Lifter - Remove and Install
C280-08 Tier 4 Engine Valve Lifter - Disassemble
C280-08 Tier 4 Engine Valve Lifter - Assemble
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Fuel Injector - Remove and Install
C280-08 Tier 4 Engine Cylinder Head - Remove
C280-08 Tier 4 Engine Cylinder Head - Install
C280-08 Tier 4 Engine Cylinder Head - Disassemble
C280-08 Tier 4 Engine Cylinder Head - Assemble
C280-08 Tier 4 Engine Piston Cooling Jets - Remove and Install
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Default Value of Work Tool Parameters
374F and 390F Excavators Tool Control System Combined Function - Electric Control: Relief Valve (Line) - Test and Adjust