Engine Oil Cooler - Remove and Install
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03424226 - Remove tube assemblies (1) and (2).
- Loosen clamps (3).
Show/hide table
Illustration 2 g03424228 - Remove bolts (4) and the bracket.
- Remove bolts (5) from the engine oil cooler .
Show/hide table
Illustration 3 g03424227 - Use a suitable pry bar to remove engine oil cooler (6) from the cylinder block.
- Install engine oil cooler (6) in reverse order of removal.
- Tighten hose clamps (3) to a torque of
14 ± 1 N·m (124 ± 9 lb in) .
- Tighten hose clamps (3) to a torque of
Caterpillar Information System:
C13 Generator Set Engine Electronic Unit Injector Sleeve - Remove and Install
349F and 352F Excavators ECM - Replace
2013/10/09 New OMD (Oil Mist Detection) Airline Tubes Are Used on Certain 3612, 3616, C280-12, and C280-16 Engines {1071}
XQ125 Generator Set Diesel Exhaust Fluid - Fill
C13 Generator Set Engine Engine Oil Filter Base - Remove and Install
C15 and C18 Industrial Engines Plate Locations and Film Locations
C13 Generator Set Engine Electronic Unit Injector - Remove and Install
C13 Generator Set Engine Fuel Transfer Pump - Remove and Install
C13 Generator Set Engine Fuel Filter Base - Remove and Install
C13 Generator Set Engine Fuel Priming Pump - Remove and Install
312F and 313F Excavators Monitoring System
3600 and C280 Diesel Engine Fluids Recommendations Diesel Exhaust Fluid (DEF) - For Use in SCR-equipped engines
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Two-Way/One Pump - Electric Control
C13 Generator Set Engine Front Cover - Remove and Install
C13 Generator Set Engine Camshaft - Remove and Install
C7.1 Industrial Engine Battery - Replace
3516C Petroleum Engines Air Lines
C13 Generator Set Engine Valve Mechanism Cover Base - Remove and Install
C13 Generator Set Engine Cylinder Head - Remove and Install
AP655F Asphalt Paver Diesel Exhaust Fluid Filter - Clean/Replace
C13 Generator Set Engine Atmospheric Pressure Sensor - Remove and Install
C13 Generator Set Engine Camshaft Position Sensor - Remove and Install
C13 Generator Set Engine Coolant Temperature Sensor - Remove and Install
C13 Generator Set Engine Engine Oil Pressure Sensor - Remove and Install