Electric Starting Motor - Remove and Install
Show/hide table
Accidental engine starting can cause injury or death to personnel working on the equipment. To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system. Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on. |
- Disconnect the batteries.
- Disconnect the harness assemblies from the electric starting motor.
Show/hide table
Illustration 1 g01042714 - Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately
36 kg (80 lb) . Remove bolts (1) that hold the electric starting motor to the flywheel housing. Remove electric starting motor (2).
- Install electric starting motor (2) in the reverse order of removal.
Caterpillar Information System:
C18 Marine Engines Alternator - Remove and Install
C18 Marine Engines Crankshaft - Remove and Install
C18 Marine Engines Crankshaft Main Bearings - Remove and Install
C18 Marine Engines Connecting Rod Bearings - Remove and Install
C7.1 Industrial Engine Monitoring System - Engine Indicators and Aftertreatment Indicators
C18 Marine Engines Pistons and Connecting Rods - Remove and Install
C18 Marine Engines Piston Cooling Jets - Remove and Install
C18 Marine Engines Cylinder Liner - Remove and Install
C7.1 Industrial Engine Gauges and Indicators
G3516C and G3516E Gas Engines Exhaust Temperature Sensor
3508B Industrial Engines Vibration Damper Guard
C18 Marine Engines Engine Oil Pan - Remove and Install
Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117} Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117}
2012/05/28 A New Console Harness Assembly Is Available for Certain Excavators {1408}
G3500 Engines Accessory Drive (Lower Left Hand)
C1.5 and C2.2 Engines for Caterpillar Built Machines Clean Emissions Module
C18 Marine Engines Fuel Priming Pump - Remove and Install
C7.1 Industrial Engine Sensors and Electrical Components
C18 Marine Engines Fuel Filter Base - Remove and Install
C7.1-XQ200 Rental Generator Set Diesel Particulate Filter Regeneration
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (Earlier) - Replace
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (3.5 EVD or Greater) - Replace
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (Earlier) - Replace
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace