Piston Cooling Jets - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the engine oil pump.
- Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
- Remove bolt (1) and piston cooling jet (2).
Show/hide table
Illustration 1 | g01004705 |
- Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
- Install piston cooling jet (2) and bolt (1). Tighten bolt (1) to a torque of
25 ± 6 N·m (18 ± 4 lb ft) . If bolt (1) is a 7/16 inch bolt, tighten bolt (1) to a torque of40 ± 8 N·m (30 ± 6 lb ft) . - Check the clearance between the piston, the piston cooling jet, and the crankshaft.
Minimum permissible clearance between the piston, the piston cooling jet, and the crankshaft ...
0.63 mm (0.025 inch)
Show/hide table
Illustration 2 | g01004705 |
End By:
- Install the engine oil pump.
Caterpillar Information System:
C18 Marine Engines Cylinder Liner - Remove and Install
C7.1 Industrial Engine Gauges and Indicators
G3516C and G3516E Gas Engines Exhaust Temperature Sensor
3508B Industrial Engines Vibration Damper Guard
C18 Marine Engines Engine Oil Pan - Remove and Install
3500 Marine Engines Aftercooler
C7.1 Industrial Engine Product Lifting
3500 Engines with EUI Option Aftercooler
G3500 Generator Sets Inlet Air System - Check
G3500 Generator Sets Generator Set Vibration - Inspect
C18 Marine Engines Camshaft Bearings - Remove and Install
C18 Marine Engines Camshaft Gear - Remove and Install
C18 Marine Engines Pistons and Connecting Rods - Remove and Install
C7.1 Industrial Engine Monitoring System - Engine Indicators and Aftertreatment Indicators
C18 Marine Engines Connecting Rod Bearings - Remove and Install
C18 Marine Engines Crankshaft Main Bearings - Remove and Install
C18 Marine Engines Crankshaft - Remove and Install
C18 Marine Engines Alternator - Remove and Install
C18 Marine Engines Electric Starting Motor - Remove and Install
Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117} Repairing Line Relief Valve Seats in Hydraulic Control Valves Using the 229-3612 Hydraulic Valve Seat Repair Kit{0738, 5117}
2012/05/28 A New Console Harness Assembly Is Available for Certain Excavators {1408}
G3500 Engines Accessory Drive (Lower Left Hand)
C1.5 and C2.2 Engines for Caterpillar Built Machines Clean Emissions Module
C18 Marine Engines Fuel Priming Pump - Remove and Install